配件

无需配件。

  1. Slide the battery latch down the side of the camera with your hands.
    • Slide the battery latch down the side of the camera with your hands.

    • The latch will automatically pop open.

    添加评论

  2. Unlatch the clip over the battery.
    • Unlatch the clip over the battery.

    • The battery will partially pop out.

    添加评论

    • Remove the battery from the camera.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Unscrew the four 3.0mm Phillips #000 screws holding the back case onto the camera; there are two screws on top and two on the bottom.

    添加评论

    • Pull the back case gently away from the rest of the camera.

    添加评论

    • Remove the two 3.0mm Phillips #000 screws holding the display to the metal backing.

    添加评论

    • Unlatch the display by sliding it towards the circuit board.

    添加评论

    • Remove the two ribbon cables attached to the circuit board by gently pulling them out of their slots.

    • Be careful not to rip the ribbon cables while disconnecting them.

    添加评论

    • The LCD is now separated from the camera.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Jenna Crawford

于2012年04月09日注册

29 信誉积分

创作了3篇指南

团队

Cal Poly, Team 17-25, Amido Spring 2012 Cal Poly, Team 17-25, Amido Spring 2012 的会员

CPSU-AMIDO-S12S17G25

4 名成员

创作了7篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 1

总计 732