简介

The following guide will walk you through the steps necessary to remove and replace your thumb dial.

配件

无需配件。

  • First, place your device with the screen side facing down.

添加评论

On the back of the device, remove the 2 screws from the thumb dial panel, which is located on the upper right hand side.
  • On the back of the device, remove the 2 screws from the thumb dial panel, which is located on the upper right hand side.

添加评论

  • Remove the screw directly above the thumb dial panel.

添加评论

  • Remove the screw from thumb dial panel on the right handed side of the device.

添加评论

  • Remove screw from lower right side of the device.

添加评论

  • Remove 1 screw from the lower left side of the device.

添加评论

  • On the bottom of the device, remove both the left and right screws.

添加评论

  • Remove the thumb dial panel by sliding it away from the device.

添加评论

  • Remove the back panel exposing the inside of the device.

添加评论

  • Locate thumb dial on top right side of the board.

添加评论

  • Follow ribbon wire to locate where it plugs into the board. The plug is a flat black square.

添加评论

  • Pull plug straight up to remove from board.

添加评论

  • Place plug back on board and push down on center to secure to board.

添加评论

  • Make sure new thumb dial is sitting flat and the screw holes line up with holes in the board.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Rob

于2011年10月04日注册

1 信誉积分

创作了2篇指南

团队

UW Stout, Team 5-6, Zhou Fall 2011 UW Stout, Team 5-6, Zhou Fall 2011 的会员

UWSTOUT-ZHOU-F11S5G6

4 名成员

创作了2篇指南

添加评论

浏览统计数据:

过去的24小时: 4

过去的7天: 7

过去的30天: 22

总计 895