简介

This guide will detail the steps necessary to remove the back cover of the Sony Bloggie 3D Player.

  1. Remove the two 2.5mm Phillips #00 screws using the Philips #00 screwdriver.
    • Remove the two 2.5mm Phillips #00 screws using the Philips #00 screwdriver.

    添加评论

  2. Use a plastic opening tool to pry the cover open.
    • Use a plastic opening tool to pry the cover open.

    • After the the cover is partly open as shown, remove the cover with your hands.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Using your hand, or a pair of tweezers, remove the ZIF connector by gently pulling it out of the dock on the circuit board.

    添加评论

    • Use a plastic opening tool to loosen the back cover off the device.

    • Once the back cover is loose, remove it gently by hand.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Timothy Tran

于2013年01月30日注册

1 信誉积分

创作了2篇指南

团队

Cal Poly, Team 7-12, Maness Winter 2013 Cal Poly, Team 7-12, Maness Winter 2013 的会员

CPSU-MANESS-W13S7G12

5 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 1

总计 277