Skip to main content

配件

没有特定配件。

  1. Place the TV face down on a flat smooth surface as to not scratch the screen. Remove the four 8mm screws attaching the stand to the TV.
    • Place the TV face down on a flat smooth surface as to not scratch the screen.

    • Remove the four 8mm screws attaching the stand to the TV.

  2. Lift the stand off the television. Lift the stand off the television.
    • Lift the stand off the television.

  3. Remove the two back panels. Remove the two back panels. Remove the two back panels.
    • Remove the two back panels.

  4. Android 维修工具包

    一个新的屏幕或电池就在一个套件之内。

    现在开始购物

    Android 维修工具包

    一个新的屏幕或电池就在一个套件之内。

    现在开始购物
  5. Remove the eight 6mm Phillips screws around the edge. Remove the two 6mm Phillips screws near the inputs.
    • Remove the eight 6mm Phillips screws around the edge.

    • Remove the two 6mm Phillips screws near the inputs.

  6. Lift and remove the back case of the television.
    • Lift and remove the back case of the television.

  7. Remove the two speaker cables and the connector from the circuit board by pinching the plastic connectors and firmly pulling up. Pull on the plastic part of the connector, even though it may seem easiest to pull on the wires. Pull on the plastic part of the connector, even though it may seem easiest to pull on the wires.
    • Remove the two speaker cables and the connector from the circuit board by pinching the plastic connectors and firmly pulling up.

    • Pull on the plastic part of the connector, even though it may seem easiest to pull on the wires.

  8. Remove the green and gray power connector from the side of the buttons panel at the top of the television. Remove the green/gray to orange/gray connector from the center of the circuit board.
    • Remove the green and gray power connector from the side of the buttons panel at the top of the television.

    • Remove the green/gray to orange/gray connector from the center of the circuit board.

  9. Remove the four 5mm phillips screws attaching the LCD and circuit board to the front case. Remove the four 5mm phillips screws attaching the LCD and circuit board to the front case.
    • Remove the four 5mm phillips screws attaching the LCD and circuit board to the front case.

  10. Lift the circuit board/LCD block from the case by lifting the near side of the circuit board and sliding it under the button frame.
    • Lift the circuit board/LCD block from the case by lifting the near side of the circuit board and sliding it under the button frame.

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Robert Hobson

于2011年01月20日注册

1,275 Reputation

创作了9篇指南

Team

Cal Poly, Team 1-11, Amido Winter 2011 Cal Poly, Team 1-11, Amido Winter 2011 的会员

CPSU-AMIDO-W11S1G11

4 名成员

创作了9篇指南

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 6

Past 30 Days: 30

All Time: 6,551