修复你的物品 社区 商店

Shark Ultimate Professional Reservoir Replacement

你所需要的

  1. Shark Ultimate Professional Reservoir Replacement, Reservoir: 步骤 1 中的图像 1，3 Shark Ultimate Professional Reservoir Replacement, Reservoir: 步骤 1 中的图像 2，3 Shark Ultimate Professional Reservoir Replacement, Reservoir: 步骤 1 中的图像 3，3

    • Remove the two screws at the back of the iron.

    • Remove the back cover piece.

    • Make sure iron is unplugged and cooled off.

    编辑

  2. Shark Ultimate Professional Reservoir Replacement: 步骤 2 中的图像 1，2 Shark Ultimate Professional Reservoir Replacement: 步骤 2 中的图像 2，2

    • Remove the two screws holding the white clamp to the iron.

    • Remove the two screws holding the black wires to the body of the iron.

    • Removing the left black wire will also free the red wire, attached by the same screw.

    编辑

  4. Shark Ultimate Professional Reservoir Replacement: 步骤 3 中的图像 1，1

    • Pull the split end of the power cord upward through the ball joint of the iron.

    • Set aside power cord.

    编辑

  5. Shark Ultimate Professional Reservoir Replacement: 步骤 4 中的图像 1，3 Shark Ultimate Professional Reservoir Replacement: 步骤 4 中的图像 2，3 Shark Ultimate Professional Reservoir Replacement: 步骤 4 中的图像 3，3

    • Remove remaining screws that hold a wire on the bottom (brown and blue).

    • Unscrew from left to right.

    • Unclip the black adapter piece on the bottom right.

    • Wires order (from left to right): Brown, Blue, Red, Black

    编辑

  6. Shark Ultimate Professional Reservoir Replacement: 步骤 5 中的图像 1，2 Shark Ultimate Professional Reservoir Replacement: 步骤 5 中的图像 2，2

    • Remove two screws (left and right) affixed to circuit board.

    编辑
结论

To reassemble your device, follow these instructions in reverse order.

3等其他人完成本指南。

作者

与1其他贡献者

Drew Carff

于10/23/17注册

868 声望

创作了5篇指南

徽章: 14

+ 11更多徽章

团队

USF Tampa, Team S1-G4, Leahy Fall 2017 USF Tampa, Team S1-G4, Leahy Fall 2017 的会员

USFT-LEAHY-F17S1G4

3 名成员

创作了10篇指南

3条评论

i am trying to replace the thermal cutoff but can’s remember the wire inside how to replace

primrose33166 - 回复

I have a constant leak in the vertical position - long after the iron is cold. The repair presented is well done. However it stopped short and doesn't get to the reservoir - thanks

Dalmacca-Hame - 回复

Then WHAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAT?

Muhammad Ahmad - 回复

添加评论

浏览统计数据:

过去 24 小时： 1

过去 7 天： 5

过去 30 天： 21

总计 2,139