简介

The Shark Rotator Powered Lift-Away has one rotatory belt. The belt is responsible for the mechanical rotations of the brushroll. Without it, the vacuum will not function. The vacuum's belt is designed to last approximately 7 years. Replacement of the belt is needed to keep the vacuum at optimal working condition. This replacement guide demonstrates how to replace the belt in the vacuum.

  1. Turn the vacuum on its side.
    • Turn the vacuum on its side.

    • Using a quarter, twist the three green locks to the unlock position.

    • Pull the bottom roller brush cover to open the vacuum.

    添加评论

  2. Using a T20 screwdriver, remove the five 15.9 mm screws on the outside cover.
    • Using a T20 screwdriver, remove the five 15.9 mm screws on the outside cover.

    添加评论

    • Remove the three 14.3 mm screws with a T20 screwdriver.

    添加评论

    • Remove the two 14.3 mm screws under the wheels with a T20 screwdriver bit.

    添加评论

    • Remove the two 15.9 mm screws from behind the wheels with a T20 bit screwdriver.

    添加评论

    • Remove the single 13.4 mm small screw behind the roller brush with a PH0 screwdriver bit.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Remove the single 13.4 mm screw from behind the belted end of the roller brush with a T20 screwdriver bit.

    添加评论

    • Turn the vacuum around.

    • Using a spudger, pry the top of the vacuum cover off. There are three tabs behind each of the clear rectangles below the headlights.

    添加评论

    • Remove both of the headlight covers with the spudger.

    添加评论

    • Remove the grey side panel on the motor side of the vaccum with a spudger. Pry under each tab to release the side panel.

    添加评论

    • Remove the two 13.4 mm screws with a T20 bit screwdriver.

    添加评论

    • Remove the single 13.4 mm screw located next to where the belt was detached, securing the motor in place, with a PH1 screwdriver.

    添加评论

    • Remove the visible side of the belt from the gear with a spudger.

    添加评论

    • Remove the grey panel from the opposite side, by uncrewing the single 13.4 mm screw with a PH1 screwdriver. This will release the container for the roller brush and belt motor.

    添加评论

    • Using the spudger, push the white end cap out of the clear plastic by placing the spudger on the roller brush side and pushing the cap outward.

    添加评论

    • Remove the belt from the gear.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Dakota Rodriguez-Ransom

于2018年10月08日注册

587 信誉积分

创作了2篇指南

团队

Cal Poly, Team S4-G6, White Fall 2018 Cal Poly, Team S4-G6, White Fall 2018 的会员

CPSU-WHITE-F18S4G6

4 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 21

总计 58