Shark Rocket Zero-M Belt Replacement

简介

This guide is intended to show how to access, remove, and replace the belt on a Shark Rocket Stick Vacuum with Self-Cleaning Brushroll. This replacement may be necessary if the brush roller is turning slowly or not at all.

你所需要的

步骤 1 Belt

Shark Rocket Zero-M Belt Replacement, Belt: 步骤 1 中的图像 1，1

Flip the vacuum on its right side.

编辑

步骤 2

Shark Rocket Zero-M Belt Replacement: 步骤 2 中的图像 3，3

Turn the T10 Security Bit screwdriver counterclockwise to remove the 15mm screw.

编辑

步骤 3

Shark Rocket Zero-M Belt Replacement: 步骤 3 中的图像 3，3

Turn the vacuum face down.
Turn the T10 Security Bit screwdriver counterclockwise to remove the 15mm screw.

编辑

步骤 4

Shark Rocket Zero-M Belt Replacement: 步骤 4 中的图像 3，3

Use a spudger to pry the side of the vacuum open.

编辑

步骤 5

Shark Rocket Zero-M Belt Replacement: 步骤 5 中的图像 3，3

Use a spudger to pry the old belt away from the two gears.
The new belt will be tight and difficult to put back on. In order to reinstall, place the belt on the brushroll, then rotate the brushroll a couple rotations to make sure the belt is aligned correctly.

编辑