修复你的物品 社区 商店

Shark Navigator Motherboard Replacement

你所需要的

  1. Shark Navigator Motherboard Replacement, Roller Brush Compartment: 步骤 1 中的图像 1，1

    • Pop out the two small wheels located on the front end of the bottom of the roller brush compartment.

    翻译

  2. Shark Navigator Motherboard Replacement: 步骤 2 中的图像 1，2 Shark Navigator Motherboard Replacement: 步骤 2 中的图像 2，2

    • Remove the 10 Phillips screws located on the bottom of the roller brush compartment. (Two of these screws are located under the wheels from the previous step.)

    • The screws have varying lengths, so keep track of where each one goes for reassembly.

    翻译

  4. Shark Navigator Motherboard Replacement: 步骤 3 中的图像 1，1

    • Remove the white plastic cover to expose the roller compartment underneath.

    翻译

  5. Shark Navigator Motherboard Replacement, Motherboard: 步骤 4 中的图像 1，1

    • There is one screw at the edge of the circuit board. Unscrew the circuit board before attempting to take it out.

    翻译

  6. Shark Navigator Motherboard Replacement: 步骤 5 中的图像 1，1

    • Take out the circuit board and replace with a new one. It may be better to allow a professional to re-wire the circuit board to the vacuum.

    翻译
结论

To reassemble your device, follow these instructions in reverse order.

3等其他人完成本指南。

作者

与3其他贡献者

Mara

于03/27/15注册

469 声望

创作了2篇指南

徽章: 9

+ 6更多徽章

团队

UMass Dartmouth, Team 5-4, Kish Spring 2015 UMass Dartmouth, Team 5-4, Kish Spring 2015 的会员

UMASSD-KISH-S15S5G4

4 名成员

创作了16篇指南

8条评论

Hi ..well done with the instructions.However I do have a Shark rotator vacuum NV501 .Unfortunately the motor on the brush is not working ,so I assume the motor is burnt.My request where could I find a replacement of the motor.I have searched a lot sites online but could not find a place to rebuild nor stock the same motor.Any help would be appreciated.Thank you.....To forward any information please do so on my email jacob.brown at hotmail.com thank you....

jacob - 回复

I couldn't figure out how to remove the bottom plate, your guide helped by informing me the last two screws are located under the little wheels. Thank you!

dylananon - 回复

When I had mine apart, two black rectangle magnet fell out, I can't figure out where the came from.

mardit - 回复

I had the same problem with the magnets - where do they go>

bjolivares1055 -

Also having problem locating both mother board and brush roller motor. Where can i purchase them?

Liz - 回复

添加评论

浏览统计数据:

过去 24 小时： 0

过去 7 天： 6

过去 30 天： 29

总计 7,695