跳转到主内容

简介

Following this guide requires cutting wires and soldering. For more information on soldering visit the soldering guide.

  1. Squeeze Dust Cup release buttons on either side of the component. Pull up to release Dust Cup.
    • Squeeze Dust Cup release buttons on either side of the component.

    • Pull up to release Dust Cup.

  2. Remove the five 15 mm screws by twisting counterclockwise with a T10 Torx screwdriver.
    • Remove the five 15 mm screws by twisting counterclockwise with a T10 Torx screwdriver.

  3. Use the iFixit opening tool to remove the top component.
    • Use the iFixit opening tool to remove the top component.

  4. iPhone 电池维修工具包

    只要 $29.99

    Buy Now

    iPhone 电池维修工具包

    只要 $29.99

    Buy Now
  5. Remove the two 15mm screws by twisting counterclockwise using the T10 Torx screwdriver.
    • Remove the two 15mm screws by twisting counterclockwise using the T10 Torx screwdriver.

  6. Remove the two 15 mm screws by twisting counterclockwise with a T10 Torx screwdriver.
    • Remove the two 15 mm screws by twisting counterclockwise with a T10 Torx screwdriver.

  7. Remove the two 15 mm screws holding the motor cover by twisting counterclockwise with a T10 Torx screwdriver.
    • Remove the two 15 mm screws holding the motor cover by twisting counterclockwise with a T10 Torx screwdriver.

  8. Cut the zip ties holding the motor using the wire cutter.
    • Cut the zip ties holding the motor using the wire cutter.

  9. Cut the wires using the wire cutters to completely remove the motor.
    • Cut the wires using the wire cutters to completely remove the motor.

    • For reassembly, use the soldering guide in the Introduction.

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Christian Fuller

于2018年10月08日注册

357 信誉积分

创作了3篇指南

团队

Cal Poly, Team S17-G5, White Fall 2018 Cal Poly, Team S17-G5, White Fall 2018 的会员

CPSU-WHITE-F18S17G5

4 名成员

创作了11篇指南

添加评论

浏览统计数据:

过去的24小时: 4

过去的7天: 12

过去的30天: 27

总计 219