跳转到主内容

简介

Instructions on how to replace a defective Sega Dreamcast power supply with a working power supply.

配件

没有特定配件。

  1. Verify that the console is disconnected from the AC outlet before you begin. Flip the console over on its back.
    • Verify that the console is disconnected from the AC outlet before you begin.

    • Flip the console over on its back.

    • Take note of your model number, in case replacement parts are needed.

  2. Remove the expansion bay by applying pressure to the small clip on the expansion bay while prying it away from the console. Remove the expansion bay by applying pressure to the small clip on the expansion bay while prying it away from the console. Remove the expansion bay by applying pressure to the small clip on the expansion bay while prying it away from the console.
    • Remove the expansion bay by applying pressure to the small clip on the expansion bay while prying it away from the console.

  3. Locate and remove all four black 12mm Phillips #02 screws from the underside of the console.
    • Locate and remove all four black 12mm Phillips #02 screws from the underside of the console.

    • Note: Remove the expansion bay to locate the fourth screw

  4. Internal components can be loose. Be careful that they do not fall out when removing the cover.
    • Internal components can be loose. Be careful that they do not fall out when removing the cover.

    • Turn the console right side up.

    • Remove the top cover by gently lifting the upper portion of the console.

  5. Unplug the device from the outlet. If you have just powered off the system, allow a few minutes for the capacitors to discharge before you begin working. Remove the white female pin head by pinching and lifting directly up on the harness.
    • Unplug the device from the outlet. If you have just powered off the system, allow a few minutes for the capacitors to discharge before you begin working.

    • Remove the white female pin head by pinching and lifting directly up on the harness.

    • Remove the two Philips #02 screws from the board.

    • Remove the power board. Using both hands, gently lift the power board away from the console without damaging the male pin head

  6. Remove the unit. Carefully remove the power board from the console by lightly grasping the board by the edge and lifting directly upward. Remove the two 10mm #02 Philips screws to detach the switch module from the console.
    • Remove the unit. Carefully remove the power board from the console by lightly grasping the board by the edge and lifting directly upward.

    • Remove the two 10mm #02 Philips screws to detach the switch module from the console.

    • Purchase a replacement power board.

结论

To reassemble your device, follow these instructions in reverse order.

5等其他人完成本指南。

Jacks216

于2009年11月25日注册

87 信誉积分

撰写一个指南

团队

Cal Poly, Team 5-1, Regan Fall 2009 Cal Poly, Team 5-1, Regan Fall 2009 的会员

CPSU-REGAN-F09S5G1

5 名成员

创作了18篇指南

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 23

过去的30天: 60

总计 13,722