跳转到主内容

简介

The purpose of this replacement guide is to remove the Sega plastic casing to expose the internal content for further repair.

配件

没有特定配件。

  1. Using a Phillips head screwdriver remove  six screws from the bottom of the console. The six screws are marked.
    • Using a Phillips head screwdriver remove six screws from the bottom of the console.

    • The six screws are marked.

  2. Remove the two screws that attach the Genesis' connector to the rest of the console.
    • Remove the two screws that attach the Genesis' connector to the rest of the console.

    • The two screws are marked in the diagram.

  3. Slide the lock tab to the left to separate the halves of the console.
    • Slide the lock tab to the left to separate the halves of the console.

  4. Lift from the left side to remove the top of the case.
    • Lift from the left side to remove the top of the case.

  5. Using the spudger, pry the cover off of the Genesis attachment.
    • Using the spudger, pry the cover off of the Genesis attachment.

  6. Lift the top of the case to remove the cover.
    • Lift the top of the case to remove the cover.

  7. Remove the faceplate by pulling it up, then out.
    • Remove the faceplate by pulling it up, then out.

结论

To reassemble the device, follow these instructions in reverse order.

另外一个人完成了本指南。

Ryan Kotzebue

于2010年10月07日注册

259 信誉积分

创作了4篇指南

团队

Cal Poly, Team 5-14, Maness Fall 2010 Cal Poly, Team 5-14, Maness Fall 2010 的会员

CPSU-MANESS-F10S5G14

5 名成员

创作了11篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 2

过去的30天: 5

总计 4,292