配件

无需配件。

  1. Place the monitor face down.
    • Place the monitor face down.

    • Remove the four 11.5mm screws with a #2 Phillips screwdriver.

    • Remove the stand by pulling it out.

    添加评论

  2. Remove two 11.5mm screws with a  #2 Phillips screwdriver.
    • Remove two 11.5mm screws with a #2 Phillips screwdriver.

    • Remove the plastic bar.

    添加评论

    • Using a #2 Phillips screwdriver, remove the six 7mm screws at the circled locations.

    添加评论

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Pry the monitor using the plastic opening tool to release the clips holding the cover on.

      • There are four clips on each side, four on the top, and one on the bottom.

      • You may hear a loud snapping noise when releasing the clips. Do not be alarmed, it is natural.

    • Once all the clips have been released, remove the cover by pulling it up.

    添加评论

    • Using the #2 Phillips screwdriver, remove the one 6mm screw.

    • Unplug the indicated cable by pulling on the base.

    • Slide the cover toward the top of the monitor.

    • Remove the cover.

    添加评论

    • Disconnect the two connectors to the speakers by gently pulling on the hard plastic straight up.

    添加评论

    • Carefully peel the tape from the board.

    添加评论

    • Flip the monitor so the screen is facing you.

    • Using Phillips #2 screwdriver remove the four 6.25 mm screws securing the speakers:

    添加评论

    • Carefully lift the speakers up.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Xenia Leon Rodriguez

于2012年09月26日注册

37 信誉积分

撰写一个指南

团队

Cal Poly, Team 16-56, Forte Fall 2012 Cal Poly, Team 16-56, Forte Fall 2012 的会员

CPSU-FORTE-F12S16G56

5 名成员

创作了7篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 1

总计 316