跳转到主内容

简介

Use this guide to replace the disc drive in your Samsung UBD-KM85C.

配件

没有特定配件。

  1. On the back side of the unit, remove the three 8.1mm screws marked with a Phillips #1 screwdriver.
    • On the back side of the unit, remove the three 8.1mm screws marked with a Phillips #1 screwdriver.

  2. From the back, lift the case upwards away from the unit then forwards, releasing the prongs on the front. From the back, lift the case upwards away from the unit then forwards, releasing the prongs on the front.
    • From the back, lift the case upwards away from the unit then forwards, releasing the prongs on the front.

  3. There is one group of wires located towards the front of the case and attached directly to the motherboard and the case. Using two fingers in a pinching motion, release the wire from the clip and disconnect it. There is one group of wires located towards the front of the case and attached directly to the motherboard and the case. Using two fingers in a pinching motion, release the wire from the clip and disconnect it. There is one group of wires located towards the front of the case and attached directly to the motherboard and the case. Using two fingers in a pinching motion, release the wire from the clip and disconnect it.
    • There is one group of wires located towards the front of the case and attached directly to the motherboard and the case. Using two fingers in a pinching motion, release the wire from the clip and disconnect it.

  4. Remove the cover from the device.
    • Remove the cover from the device.

  5. The disk drive is the large metallic rectangular unit that occupies a third of the space inside the unit.
    • The disk drive is the large metallic rectangular unit that occupies a third of the space inside the unit.

  6. The disk drive has four 6.5mm screws located near each of its corners that hold it onto the frame. Use a #1 Phillips head screwdriver to remove these screws. The disk drive has four 6.5mm screws located near each of its corners that hold it onto the frame. Use a #1 Phillips head screwdriver to remove these screws.
    • The disk drive has four 6.5mm screws located near each of its corners that hold it onto the frame. Use a #1 Phillips head screwdriver to remove these screws.

  7. The disk drive has two connections to the motherboard that can be disconnected by pulling on the blue plastic tabs. The disk drive has two connections to the motherboard that can be disconnected by pulling on the blue plastic tabs. The disk drive has two connections to the motherboard that can be disconnected by pulling on the blue plastic tabs.
    • The disk drive has two connections to the motherboard that can be disconnected by pulling on the blue plastic tabs.

  8. Once the connections are unplugged and the screws are removed, the disk drive can be lifted out. The previous steps can be done in the reverse order to replace the part.
    • Once the connections are unplugged and the screws are removed, the disk drive can be lifted out. The previous steps can be done in the reverse order to replace the part.

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

James Edwards

于2018年02月01日注册

627 信誉积分

创作了5篇指南

团队

Baylor, Team S2-G1, Johnson Spring 2018 Baylor, Team S2-G1, Johnson Spring 2018 的会员

BU-JOHNSON-S18S2G1

3 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 9

总计 86