跳转到主内容

简介

The keypad may become broken over time, this guide will assist in the replacement of the keypad.

  1. Slide the latch on the back of the phone up.
    • Slide the latch on the back of the phone up.

  2. Remove the battery.
    • Remove the battery.

  3. After removing the battery, remove the four small Phillips-head screws with a #0 Phillips screwdriver.
    • After removing the battery, remove the four small Phillips-head screws with a #0 Phillips screwdriver.

  4. Using a thumbtack, pry the small plastic cover from the case near the base of the antenna.
    • Using a thumbtack, pry the small plastic cover from the case near the base of the antenna.

  5. iPhone 电池维修工具包

    只要 $29.99

    Buy Now

    iPhone 电池维修工具包

    只要 $29.99

    Buy Now
  6. With a #0 Phillips screwdriver remove the screw which you just uncovered.
    • With a #0 Phillips screwdriver remove the screw which you just uncovered.

  7. Using the spudger, carefully pry the case apart starting near the charging port. Ease the case open. Then disconnect the small power connector near the top of the phone.
    • Using the spudger, carefully pry the case apart starting near the charging port. Ease the case open.

    • Then disconnect the small power connector near the top of the phone.

  8. Gently pry up the ribbon-type connector with the spudger.
    • Gently pry up the ribbon-type connector with the spudger.

  9. Carefully pry the logic board from the case with the spudger.
    • Carefully pry the logic board from the case with the spudger.

  10. Once the logic board has been removed, peel the keypad up.
    • Once the logic board has been removed, peel the keypad up.

  11. When using a spudger the keypad housing comes off quite easily, although it may be necessary to guide the ribbon cable through the slot in the housing. When using a spudger the keypad housing comes off quite easily, although it may be necessary to guide the ribbon cable through the slot in the housing.
    • When using a spudger the keypad housing comes off quite easily, although it may be necessary to guide the ribbon cable through the slot in the housing.

结论

To reassemble your device, follow these instructions in reverse order.

Nathan Brink

于2010年04月11日注册

1 信誉积分

创作了7篇指南

团队

Cal Poly, Team 34-59, Forte Spring 2010 Cal Poly, Team 34-59, Forte Spring 2010 的会员

CPSU-FORTE-S10S34G59

4 名成员

创作了14篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 1

总计 1,541