Samsung Refrigerator Door Sensors Replacement

简介

This guide shows how to remove and replace the door sensors in your Samsung refrigerator. If your refrigerator has only one door, you will have only one sensor.

The Samsung fridge uses a magnetic reed switch for each French door. If these sensors fail, the refrigerator will think a door is always open or closed.

This guide will work for most Samsung Refrigerators. This guide is based on a model RF28R7201SG Refrigerator. If you have a different model, you may encounter some minor disassembly differences, but the overall repair process will be the same.

你所需要的

步骤 1 Unplug your refrigerator

Samsung Refrigerator Door Sensors Replacement, Unplug your refrigerator: 步骤 1 中的图像 1，1

Unplug your refrigerator before you begin your repair.

编辑

步骤 2 Remove the hinge cover

Samsung Refrigerator Door Sensors Replacement, Remove the hinge cover: 步骤 2 中的图像 1，1

Remove the screws securing the hinge cover (aka top table) on the top of the refrigerator.

编辑

步骤 3

Lift the edges of the hinge cover to loosen it from the refrigerator.
Don't try to fully remove the cover, as it's still attached to the refrigerator by a few cables.
Flip the hinge cover over to access the cables underneath.

编辑

步骤 4

Use your fingers to release the wire connectors under the hinge cover.
Disconnect the wiring so you can remove the hinge cover.

编辑

步骤 5

Remove the hinge cover.

编辑

步骤 6 Sensor information

Samsung Refrigerator Door Sensors Replacement, Sensor information: 步骤 6 中的图像 1，2

Samsung Refrigerator Door Sensors Replacement, Sensor information: 步骤 6 中的图像 2，2

The door sensors are located in the hinge cover. In this example, the hinge cover has two door sensors:
The left door sensor
The left door sensor connector
The right door sensor
The right door sensor connector
Depending on your situation, you may need to replace either or both sensors.