简介

This guide will show you how to replace your microphone.

Slide your fingernail into the slit at the bottom of the phone to remove the back cover.
  • Slide your fingernail into the slit at the bottom of the phone to remove the back cover.

添加评论

Place your finger in either of the bottom corner of the battery slot and lift to remove the battery.
  • Place your finger in either of the bottom corner of the battery slot and lift to remove the battery.

添加评论

  • Remove six 5 mm Phillips #0 screws from the back of the phone.

添加评论

  • Insert a plastic opening tool into the seam between the back case and the rest of the phone.

  • Working along the seam, pry the back from the phone.

添加评论

  • Remove the two remaining 3.75 mm Phillips screws.

添加评论

  • Firmly grip the black lever with tweezers

  • Use the tweezers to flip the black lever up so that it is perpendicular to the motherboard.

添加评论

  • Carefully use the tweezers to slide the black ZIF cable out of the socket.

添加评论

  • Use the tweezers to unclip the black connector as shown.

添加评论

  • Use the tweezers to unclip the orange flexible circuit board from the side of the phone.

添加评论

  • Use the tweezers to unclip the other orange, smaller flexible circuit board.

  • Work carefully. This is a very delicate part of the phone that can easily be broken.

添加评论

  • Slide one side of the tweezers underneath the red and blue wires of the capacitor.

  • Carefully apply pressure away from the phone to lift.

添加评论

  • Carefully tilt the motherboard up from the back of the phone.

  • Don't remove the motherboard completely. There is one more clip on the backside of the motherboard that needs to be removed.

  • Use tweezers to unclip the black connector.

添加评论

  • Hold the phone by the black plastic at the ends and slightly bend them down so that the middle of the phone is the highest point. Apply pressure slowly until the until the grey portion pops off.

添加评论

  • Insert the tweezers into the hole as shown so that they are wedged between the LCD and grey plastic.

  • Slide the tweezers underneath the LCD, around the three silver edges, until the entire display is lifted from grey plastic.

添加评论

  • Find the rubber microphone backing on the bottom of the back of the front cover as shown in the picture. Use tweezers to pluck the microphone from the casing.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Collin Gordon

于2013年04月08日注册

45 信誉积分

创作了6篇指南

团队

Cal Poly, Team 17-1, Regan Spring 2013 Cal Poly, Team 17-1, Regan Spring 2013 的会员

CPSU-REGAN-S13S17G1

4 名成员

创作了18篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 1

总计 181