跳转到主内容

Fix Your Stuff

Right to Repair

Parts & Tools

简介

If the heart rate monitor on the watch no longer detects your heart rate, then replacing the back may fix it.

  1. Flip the watch over so that the face is down. Using a Y#0 screwdriver, unscrew the four 3.5 millimeter tri-head screws.
    • Flip the watch over so that the face is down.

    • Using a Y#0 screwdriver, unscrew the four 3.5 millimeter tri-head screws.

    • Remember to turn off the watch to avoid being shocked.

  2. Using your finger, push forward on the release while pulling up on the strap. You may find it helpful to use the flat end of a spudger to push on the release instead of your finger.
    • Using your finger, push forward on the release while pulling up on the strap.

    • You may find it helpful to use the flat end of a spudger to push on the release instead of your finger.

  3. Repeat the procedure from step 2 for the other strap. Repeat the procedure from step 2 for the other strap.
    • Repeat the procedure from step 2 for the other strap.

  4. Insert a plastic opening tool between the top and bottom portions of the case, and gently pry off the back. Do not insert the tool more than 3 millimeters into the case. Inserting more than 3 mm may damage the seal and electric components.
    • Insert a plastic opening tool between the top and bottom portions of the case, and gently pry off the back.

    • Do not insert the tool more than 3 millimeters into the case. Inserting more than 3 mm may damage the seal and electric components.

结论

To reassemble your device, follow these instructions in reverse order.

Jacob Baldwin

于2017年02月20日注册

2,586 信誉积分

创作了5篇指南

团队

USF Tampa, Team S2-G3, Sullivan Spring 2017 USF Tampa, Team S2-G3, Sullivan Spring 2017 的会员

USFT-SULLIVAN-S17S2G3

3 名成员

创作了18篇指南

And where do you get the new replacement back? And does it just snap back on?

shawntravis76 - 回复

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 2

总计 265