跳转到主内容
  1. 这个步骤还没有翻译 帮忙翻译一下

    Insert the wedge of the nylon spudger and slide it between the front and back panels until the back comes off. Insert the wedge of the nylon spudger and slide it between the front and back panels until the back comes off.
    • Insert the wedge of the nylon spudger and slide it between the front and back panels until the back comes off.

  2. 这个步骤还没有翻译 帮忙翻译一下

    Peel off the green tape that covers the connectors for the three black strips.
    • Peel off the green tape that covers the connectors for the three black strips.

    • Use the tip of a spudger or your fingernail to flip up the small retaining flaps.

  3. 这个步骤还没有翻译 帮忙翻译一下

    Use a Phillips #00  screwdriver to remove the four 3.2mm  screws.
    • Use a Phillips #00 screwdriver to remove the four 3.2mm screws.

  4. 这个步骤还没有翻译 帮忙翻译一下

    Detach the red, blue, and black cables by prying up on the white connector from the motherboard.
    • Detach the red, blue, and black cables by prying up on the white connector from the motherboard.

    • If using fingers instead, pull evenly on the full width of the cable so the wires are not overly strained.

    • If you pull too hard you can damage the connector on the circuit board. Use a spudger or tweezers to push down on the black connector on the board while gently prying the battery connector loose. The connector breaks VERY easily.

  5. 这个步骤还没有翻译 帮忙翻译一下

    Use the nylon spudger to remove the battery by prying up on the edges.
    • Use the nylon spudger to remove the battery by prying up on the edges.

  6. 这个步骤还没有翻译 帮忙翻译一下

    Once the battery is loose,  lift it out of the device.
    • Once the battery is loose, lift it out of the device.

  7. 这个步骤还没有翻译 帮忙翻译一下

    Remove the two 2.7mm Phillips #00 screws from the micro USB port. Remove the micro USB retaining bracket.
    • Remove the two 2.7mm Phillips #00 screws from the micro USB port.

    • Remove the micro USB retaining bracket.

  8. 这个步骤还没有翻译 帮忙翻译一下

    Use the flat end of a spudger to disconnect the micro USB port. Remove the micro USB port.
    • Use the flat end of a spudger to disconnect the micro USB port.

    • Remove the micro USB port.

终点

7等其他人完成本指南。

Blake Klein

于2017年01月29日注册

61,570 信誉积分

创作了57篇指南

Thank you so much for simplifying this guide for us novices. I have tried watching two videos where they assume I already have some Samsung repair knowledge. I feel confident I will be able to get the tablet up and charging in no time.

Stacie Harper - 回复

There is no need to remove the battery, only detach the power connector, cheers!

Bartosz Kaczynski - 回复

添加评论

浏览统计数据:

过去的24小时: 6

过去的7天: 23

过去的30天: 94

总计 4,924