跳转到主内容

修复你的物品

维修的权力

商店

简介

Before taking apart the tablet, be sure to buy the replacement battery. You can find batteries online by searching, “Samsung Galaxy Tablet 4 10.1 battery.” The battery used in this guide is the 6800 mAh 3.7V.

Below is a link to purchase the recommended battery:

https://www.amazon.com/Samsung-GALAXY-Ta...

  1. Insert the wedge of the nylon spudger and slide it between the front and back panels until the back comes off. Insert the wedge of the nylon spudger and slide it between the front and back panels until the back comes off.
    • Insert the wedge of the nylon spudger and slide it between the front and back panels until the back comes off.

  2. Peel off the green tape that covers the connectors for the three black strips.
    • Peel off the green tape that covers the connectors for the three black strips.

    • Use the tip of a spudger or your fingernail to flip up the small retaining flaps.

  3. Use a Phillips #00  screwdriver to remove the four 3.2mm  screws.
    • Use a Phillips #00 screwdriver to remove the four 3.2mm screws.

  4. Detach the red, blue, and black cables by prying up on the white connector from the motherboard.
    • Detach the red, blue, and black cables by prying up on the white connector from the motherboard.

    • If using fingers instead, pull evenly on the full width of the cable so the wires are not overly strained.

    • If you pull too hard you can damage the connector on the circuit board. Use a spudger or tweezers to push down on the black connector on the board while gently prying the battery connector loose. The connector breaks VERY easily.

  5. Use the nylon spudger to remove the battery by prying up on the edges.
    • Use the nylon spudger to remove the battery by prying up on the edges.

  6. Once the battery is loose,  lift it out of the device.
    • Once the battery is loose, lift it out of the device.

结论

To reassemble your device, follow these instructions in reverse order.

43等其他人完成本指南。

Samantha Gunzl

于2016年09月30日注册

548 信誉积分

撰写一个指南

团队

Cal Poly, Team 18-1, Forte Fall 2016 Cal Poly, Team 18-1, Forte Fall 2016 的会员

CPSU-FORTE-F16S18G1

5 名成员

创作了3篇指南

Well, I know what I did wrong. I thought I was super careful, but I damaged the black connector. (Please pay extra attention to the red warning area in Gunzl’s instructions.) It separates from the board extremely easy. My husband was worried about my taking on this task. I know what I did wrong, but that doesn’t help the fact that I will be purchasing another tablet for him. I’m not sure I will purchase another Samsung, but perhaps all the tablets has such fragile inner workings.

Racquel Naylor - 回复

Don’t worry, you’re not the only one! :(

Ashley Lahm -

Thank you! Will try this.

affriedl - 回复

the battery on this tablet is terrible, once i get the parts, your guide will come in handy.

kcole - 回复

Regarding Step 4, Take note of the red warning comment! Very easy to pull up the connector off the board!!!

Unfortunately I just that because I didn’t hold down the connectors with tweezers (or something) and then botched an attempted reflow of the solder, costing even more time and money! :(

Ashley Lahm - 回复

添加评论

浏览统计数据:

过去的24小时: 24

过去的7天: 138

过去的30天: 580

总计 37,936