简介

This guide will show you how to remove the current screen on your Samsung Droid Charge and install a new one.

  1. Open up the back case on the phone from the groove in the bottom of the phone.
    • Open up the back case on the phone from the groove in the bottom of the phone.

    • You can do this by inserting a fingernail or similarly thin object into the groove and pulling up with mild force.

    添加评论

  2. Below the left part of the bottom of the battery area there will be a groove large enough to fit in a finger or screw driver head.
    • Below the left part of the bottom of the battery area there will be a groove large enough to fit in a finger or screw driver head.

    • Use the groove to lever out the battery gently, in order to not damage either the battery or phone. Store the battery in a safe place.

    添加评论

    • Push the SD card further into its metal slot until you hear a click.

    • Release the card, and it should automatically eject itself.

    • Remove the SD card.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Slide the SIM card out of its casing by pushing on it and sliding it upward.

    添加评论

    • Locate the 7 small black screws located around the edge of the phone under the battery cover.

    • With a small Philips head screwdriver, remove each of the screws and place them in a secure location.

    添加评论

    • Locate your pry tool.

    • Insert the pry tool into the plastic edge that runs along the sides of the phone. Doing so will allow you to remove part of the back casing.

    • Use a prying motion to lift the casing up.

    • Repeat this motion all around the screen edge until the casing pops off.

    添加评论

    • Release the one pop connector for the motherboard located on the right.

    • Release the volume button flex cable on the right.

    • Release the power button flex cable on the right.

    • Now the motherboard can be removed. Simply lift out the motherboard and set aside.

    添加评论

    • Using a hairdryer or heat gun, warm the phone. Doing so will warm the adhesive holding the screen in place, allowing us to continue disassembling the device.

    • Use the pry tool to pry the screen off the casing. You may need to use force to overcome the adhesive.

    • Work carefully to prevent damage to the phone.

    添加评论

    • You can now swap out the old screen for your new one.

    添加评论

终点

4等其他人完成本指南。

Luke Gordon

于2012年09月26日注册

169 信誉积分

创作了5篇指南

团队

Cal Poly, Team 15-44, Forte Fall 2012 Cal Poly, Team 15-44, Forte Fall 2012 的会员

CPSU-FORTE-F12S15G44

4 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 4

总计 2,689