简介

The speaker is easily damaged by playing music too loud. This part is easily replaced.

Remove the back cover by pressing on  the bottom section of the phone and sliding the bottom piece downward.
  • Remove the back cover by pressing on the bottom section of the phone and sliding the bottom piece downward.

  • Lift up the back cover.

添加评论

Place your finger on the bottom of the battery and lift to remove.
  • Place your finger on the bottom of the battery and lift to remove.

添加评论

Replace the old battery with the new one.
  • Replace the old battery with the new one.

添加评论

Mac RAM 套件
加速你的Mac。充分利用它的内存。
Mac RAM 套件
从Mac中清理出更多内存。
Insert the spudger underneath the bottom section of the phone.
  • Insert the spudger underneath the bottom section of the phone.

  • Gently lift and push the spudger to slide the bottom section down to reveal two hidden screws.

添加评论

Remove the six 4.5mm #000 Phillips screws.
  • Remove the six 4.5mm #000 Phillips screws.

添加评论

Starting at a bottom corner, use the spudger to separate the rear case from the front display. Move the spudger towards the top on both sides. The plastic opening tool is easier to use for this step. Be careful when detaching the top. Free each side, stopping short of the center of the cover. Apply backward pressure on both corners with a finger applying pressure on the center, and slide the whole back cover toward the bottom of the device. Note: forcing the cover can result in cracked plastic.
  • Starting at a bottom corner, use the spudger to separate the rear case from the front display.

  • Move the spudger towards the top on both sides. The plastic opening tool is easier to use for this step.

  • Be careful when detaching the top. Free each side, stopping short of the center of the cover. Apply backward pressure on both corners with a finger applying pressure on the center, and slide the whole back cover toward the bottom of the device. Note: forcing the cover can result in cracked plastic.

添加评论

Separate the rear case from the phone.
  • Separate the rear case from the phone.

添加评论

Use the Phillips 00 screwdriver to remove the single screw holding the speaker assembly to the LCD.
  • Use the Phillips 00 screwdriver to remove the single screw holding the speaker assembly to the LCD.

添加评论

Use the plastic opening tool to lift the bottom tab of the plastic ribbon cable connector. Be careful not to use excessive force, you are only releasing the tab that holds the cable in. Pull out the ribbon cable.
  • Use the plastic opening tool to lift the bottom tab of the plastic ribbon cable connector. Be careful not to use excessive force, you are only releasing the tab that holds the cable in.

  • Pull out the ribbon cable.

  • Use a spudger or plastic opening tool to lift up the speaker, and use your hands to remove it.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

11等其他人完成本指南。

Drew Bentz

于2011年09月22日注册

565 信誉积分

创作了5篇指南

团队

Cal Poly, Team 20-25, Maness Fall 2011 Cal Poly, Team 20-25, Maness Fall 2011 的会员

CPSU-MANESS-F11S20G25

3 名成员

创作了9篇指南

It was clear enough to follow, don't know why it got the incorrect text caveat.

I gotta get one of those spudger sets.

Also it did not say where to get the actual replacement speaker.

G Trieste - 回复

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 8

总计 8,297