简介

The following guide details steps on how to reach your SONY Ericsson's motherboard. Once you reach the motherboard, you can identify issues the part may have.

Flick the two lock tabs into the unlocked positions by pushing each button forward.
  • Flick the two lock tabs into the unlocked positions by pushing each button forward.

添加评论

Pop the back cover up using the groove on the top of the phone.
  • Pop the back cover up using the groove on the top of the phone.

添加评论

  • You can now access the phone's battery.

  • Using a spudger, remove the battery and set it aside.

添加评论

  • Remove the two small rubber pieces that cover the lower screws.

  • Using a T-6 Torx wrench or screwdriver, remove all four of the small screws at the top and bottom corners on the back of the phones.

添加评论

  • Gently pry off the faceplate using a plastic opening tool.

  • Insert the plastic opening tool into the middle of the front and back panels of the phone.

添加评论

  • Seperate the front and back panels that were pryed open with the plastic opening tool.

添加评论

  • Now that the faceplate is off, use tweezers to separate the backplate from the inner manifold.

添加评论

  • With both insides of the phone exposed, gently detach the ribbon cable connecting the two inner sides. You can now separate the two sides of the phone.

添加评论

  • The motherboard is located on the side with the green and black bumper on the bottom. Use the plastic opening tool to pry the bumper off.

添加评论

  • To remove the motherboard, apply upwards pressure on the bottom green tab.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Bob

于2013年04月15日注册

301 信誉积分

创作了3篇指南

团队

SUNY Cortland, Team 1-3, Getto Spring 2013 SUNY Cortland, Team 1-3, Getto Spring 2013 的会员

SUNYCORT-GETTO-S13S1G3

3 名成员

创作了8篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 2

过去的30天: 5

总计 562