Roconia Q6 Button Replacement

简介

This manual provides instructions for changing the Ronconia Q6 projector's OK button. The OK button is crucial for menu navigation and selection confirmation. Whether you're a novice or experienced, this guide offers straightforward, easy-to-follow steps to simplify the replacement process.

你所需要的

步骤 1 Top Cover

Roconia Q6 Button Replacement, Top Cover: 步骤 1 中的图像 1，2

Roconia Q6 Button Replacement, Top Cover: 步骤 1 中的图像 2，2

Flip your device upside down so that the interface is facing downwards.

翻译

步骤 2

Roconia Q6 Button Replacement: 步骤 2 中的图像 3，3

The device is supported by rubber pieces located at the bottom extremities.
There are screws beneath the rubber pieces that can be removed. Remove all four 1.1 mm Phillips #1 screws by using the Phillips #0 screwdriver.

翻译

步骤 3

Roconia Q6 Button Replacement: 步骤 3 中的图像 3，3

Turn device over again and pry open the device to remove the cover.

翻译

步骤 4

Roconia Q6 Button Replacement: 步骤 4 中的图像 3，3

Pull out the cable that is connected to the top cover to fully separate.

翻译

步骤 5 Button

Roconia Q6 Button Replacement, Button: 步骤 5 中的图像 1，2

Roconia Q6 Button Replacement, Button: 步骤 5 中的图像 2，2

Use a Phillips #0 screwdriver to remove each of the 5.2 mm screws from the sensor board inside the cover.

翻译

步骤 6

Roconia Q6 Button Replacement: 步骤 6 中的图像 3，3

Remove the motherboard and you will see the the pieces that help control the buttons.
Locate where the OK button is placed.
Remove the part that helps control the OK button by pulling it out