跳转到主内容

简介

In this guide, we will show you how to replace the camera in a Ring Stick Up Cam. You will need a Phillips #00 screwdriver and a plastic opening tool.

  1. Remove the six 6mm Phillips #00 screws from the back of the device.
    • Remove the six 6mm Phillips #00 screws from the back of the device.

  2. Pry off the aluminum plate using a plastic opening tool.
    • Pry off the aluminum plate using a plastic opening tool.

  3. Remove the two 6mm Phillips #00 screws that were under the aluminum plate.
    • Remove the two 6mm Phillips #00 screws that were under the aluminum plate.

  4. Pry off the back cover using a plastic opening tool.
    • Pry off the back cover using a plastic opening tool.

  5. Disconnect the battery power leads using a plastic opening tool.
    • Disconnect the battery power leads using a plastic opening tool.

  6. Use a plastic opening tool to loosen the adhesive holding the battery in place and remove the battery by hand.
    • Use a plastic opening tool to loosen the adhesive holding the battery in place and remove the battery by hand.

  7. Remove the three silver  6mm Phillips #00 screws holding the motherboard in the device.
    • Remove the three silver 6mm Phillips #00 screws holding the motherboard in the device.

  8. Disconnect the ribbon connector shown in the photo.
    • Disconnect the ribbon connector shown in the photo.

  9. Remove the motherboard from the device by hand.
    • Remove the motherboard from the device by hand.

  10. Remove the two black 5mm Phillips #00 screws holding the camera board into the device.
    • Remove the two black 5mm Phillips #00 screws holding the camera board into the device.

    • Remove the single silver 10mm Phillips #00 screw holding the camera board into the device.

  11. Remove the three plastic spacers shown in the photo by hand.
    • Remove the three plastic spacers shown in the photo by hand.

  12. Carefully disconnect the camera board from the daughterboard by sliding a  plastic opening tool between the camera board and the daughterboard.
    • Carefully disconnect the camera board from the daughterboard by sliding a plastic opening tool between the camera board and the daughterboard.

  13. Lift the camera board out of the housing using your hand.
    • Lift the camera board out of the housing using your hand.

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Ao Li

于2019年02月06日注册

245 信誉积分

撰写一个指南

团队

UC Davis, Team S18-G3, Lore Winter 2019 UC Davis, Team S18-G3, Lore Winter 2019 的会员

UCD-LORE-W19S18G3

3 名成员

创作了4篇指南

Where can I purchase a new lens?

Javier Casas - 回复

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 18

过去的30天: 84

总计 674