修复你的物品 社区 商店

Retro-Bit Retro Duo Circuit Board in Controller(s) Replacement

简介

If your controller(s) malfunction, you can replace the circuit boards. You only need a Phillips #1 screwdriver.

你所需要的

  1. Retro-Bit Retro Duo Circuit Board in Controller(s) Replacement, Circuit Board in Controller(s): 步骤 1 中的图像 1，3 Retro-Bit Retro Duo Circuit Board in Controller(s) Replacement, Circuit Board in Controller(s): 步骤 1 中的图像 2，3 Retro-Bit Retro Duo Circuit Board in Controller(s) Replacement, Circuit Board in Controller(s): 步骤 1 中的图像 3，3

    • With the controller on its face, remove the five 6 mm Phillips #1 screws.

    • After removing the screws, carefully lift the controller casing .

    编辑

  3. Retro-Bit Retro Duo Circuit Board in Controller(s) Replacement: 步骤 2 中的图像 1，3 Retro-Bit Retro Duo Circuit Board in Controller(s) Replacement: 步骤 2 中的图像 2，3 Retro-Bit Retro Duo Circuit Board in Controller(s) Replacement: 步骤 2 中的图像 3，3

    • Pinch the top and bottom of the shoulder buttons and lift them out.

    • Below each shoulder button, there are small elastic pads. To remove them, pinch the pads and slide them out.

    • Removing the elastic pads allows easier circuit board access.

    编辑

  4. Retro-Bit Retro Duo Circuit Board in Controller(s) Replacement: 步骤 3 中的图像 1，3 Retro-Bit Retro Duo Circuit Board in Controller(s) Replacement: 步骤 3 中的图像 2，3 Retro-Bit Retro Duo Circuit Board in Controller(s) Replacement: 步骤 3 中的图像 3，3

    • Carefully lift the circuit board from the controller case.

    编辑
结论

To reassemble your device, follow these instructions in reverse order.

作者

与3其他贡献者

Evelyn

于09/25/17注册

223 声望

创作了2篇指南

徽章: 4

+1个徽章

团队

USF Tampa, Team S4-G4, Eyestone Fall 2017 USF Tampa, Team S4-G4, Eyestone Fall 2017 的会员

USFT-EYESTONE-F17S4G4

3 名成员

创作了10篇指南

0条评论

添加评论

浏览统计数据:

过去 24 小时： 0

过去 7 天： 1

过去 30 天： 6

总计 977