修复你的物品 社区 商店

Replacing the Battery of the Fujitsu Primergy

简介

Not even a screw is required to change the bios battery.

By replacing the CMOS battery the setting will be erased and set by default, in case of problems with the bios its common practice to remove and reinsert the battery to reset it.

你所需要的

精选文档

  1. Replacing the Battery of the Fujitsu Primergy, Open the Case: 步骤 1 中的图像 1，1

    • Pull the green tab on the side and pull back the panel

    • Remove the panel and store it somewhere

    • On page 37 of the manual there is a description similar to that of this article

    翻译

  2. Replacing the Battery of the Fujitsu Primergy, Remove the fan on the CPUs: 步骤 2 中的图像 1，1

    • Press the two green tabs and pull up the fan on the CPUs

    • Be careful to take it easy, the fan cable is short (red arrow)

    翻译

  4. Replacing the Battery of the Fujitsu Primergy, Remove PCIe cards: 步骤 3 中的图像 1，2 Replacing the Battery of the Fujitsu Primergy, Remove PCIe cards: 步骤 3 中的图像 2，2

    • Press on the green clips

    • Slowly pull the cards out of the slots

    • It would be advisable to connect to the ground first

    翻译

  5. Replacing the Battery of the Fujitsu Primergy, Remove the battery: 步骤 4 中的图像 1，2 Replacing the Battery of the Fujitsu Primergy, Remove the battery: 步骤 4 中的图像 2，2

    • Press on the clip (in red) and the battery should come out by itself

    • Insert the new battery

    • Check the polarity, usually the writings must be upwards

    翻译
结论

By replacing the CMOS battery the settings should remain saved

由衷感谢以下译者：

it en

100%

Marc developer

Domenyck Paoly

这些译者帮助我们修补全世界！ 您也想加入吗？
开始翻译 ›

附加文件

作者

与1其他贡献者

Marc developer

于08/16/21注册

1,348 声望

创作了4篇指南

徽章: 21

+ 18更多徽章

团队

iFanatics iFanatics 的会员

Community

54 名成员

创作了156篇指南

0条评论

添加评论

浏览统计数据:

过去 24 小时： 0

过去 7 天： 13

过去 30 天： 70

总计 616