简介

Nokia 6500 Slide LCD replacement. Save your money & time. Do it for as low as IDR 50,000 and it takes less than 10 minutes.

配件

无需配件。

  1. Press the eject button to open battery enclosure. Remove battery, sim card and micro sd card. Press the eject button to open battery enclosure. Remove battery, sim card and micro sd card. Press the eject button to open battery enclosure. Remove battery, sim card and micro sd card.
    • Press the eject button to open battery enclosure. Remove battery, sim card and micro sd card.

  2. Remove four screws using torx 5 screwdriver.
    • Remove four screws using torx 5 screwdriver.

  3. Pry each side evenly around its edges. The phone should start to split into two halves. Pry each side evenly around its edges. The phone should start to split into two halves. Pry each side evenly around its edges. The phone should start to split into two halves.
    • Pry each side evenly around its edges. The phone should start to split into two halves.

  4. 所有超过US$100.00或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店

    善于维修,即天赋异禀。

    与 #ImAGenius 分享您的维修故事

    我们都是天才

    与 #ImAGenius 分享您的维修故事

  5. The top and bottom half of the phone is still connected by two ribbon connectors each side. Use a thin plastic like a credit card to carefully disconnect it. The top and bottom half of the phone is still connected by two ribbon connectors each side. Use a thin plastic like a credit card to carefully disconnect it.
    • The top and bottom half of the phone is still connected by two ribbon connectors each side. Use a thin plastic like a credit card to carefully disconnect it.

  6. Make sure all components stay on each side (see picture).
    • Make sure all components stay on each side (see picture).

  7. Pull the black part away from the rest of the phone in the direction shown by the white arrows follows by the blue. This way you can accessing the two screws at the bottom of the phone. Remove four srews using torx 5 screwdriver.
    • Pull the black part away from the rest of the phone in the direction shown by the white arrows follows by the blue.

    • This way you can accessing the two screws at the bottom of the phone. Remove four srews using torx 5 screwdriver.

  8. Carefully pry out the lcd cover. Make sure the board connector pass the cover by angle.
    • Carefully pry out the lcd cover.

    • Make sure the board connector pass the cover by angle.

  9. Disconnect the LCD connector. Carefully peel the ribbon away from the back of the screen. It's held in place with double sided tape. The LCD screen will now be loose and can be removed and replace with the new one.
    • Disconnect the LCD connector.

    • Carefully peel the ribbon away from the back of the screen. It's held in place with double sided tape.

    • The LCD screen will now be loose and can be removed and replace with the new one.

结论

To reassemble your device, follow these instructions in reverse order.

dwi

于2013年07月02日注册

136 信誉积分

撰写一个指南

Great - have screen in. Now, have you ever replaced the port / jack for the charger? Mine will not accept the prong all of a sudden

Brenda Kent - 回复

浏览统计数据:

过去的24小时: 1

过去的7天: 5

过去的30天: 16

总计 2,707