1. Pry off back plastic, starting at the gap provided at the bottom of the phone. A spudger can be used to make this easier.
    • Pry off back plastic, starting at the gap provided at the bottom of the phone. A spudger can be used to make this easier.

    添加评论

  2. Remove battery, prying from the provided gap at the upper-right corner of the battery
    • Remove battery, prying from the provided gap at the upper-right corner of the battery

    添加评论

    • Depress MicroSD to eject it from the side of the case.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Remove 4 corner screws, you may have to remove a "VOID" sticker from one of the screw heads.

    添加评论

    • Using a spudger, unclip the nine clips holding the back panel to the front panel, highlighted in included pictures.

    • Start at the top, and work clockwise, being careful not to break the clips.

    • There are, 1, 3, 2, and 3 clips on each side, respectively.

    • After the clips are disengaged, there are no cables holding the back panel in place.

    添加评论

    • Use your spudger to release the remaining clips, disconnecting the ribbon cables from the logic board.

    添加评论

    • Remove 2 Phillips Screws holding the logic board to the front panel.

    • Gently lift the logic board off the front panel.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

6等其他人完成本指南。

Mobile Rapid Response Unit

于2012年05月07日注册

1,879 信誉积分

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 4

总计 3,845