Before disassembling the blender base, make sure the blender disconnected from any power outlet. Lift the jar straight up from the base without tilting the jar.
  • Before disassembling the blender base, make sure the blender disconnected from any power outlet.

  • Lift the jar straight up from the base without tilting the jar.

添加评论

Remove the top three 1/4 inch base screws using a Philip's head screwdriver.
  • Remove the top three 1/4 inch base screws using a Philip's head screwdriver.

添加评论

Remove the two base leg covers next to the power cord using pliers or a flat-head screwdriver. This provides access to the base screws beneath.
  • Remove the two base leg covers next to the power cord using pliers or a flat-head screwdriver.

  • This provides access to the base screws beneath.

添加评论

Mac RAM 套件
加速你的Mac。充分利用它的内存。
Mac RAM 套件
从Mac中清理出更多内存。
Remove the following screws that secure the top and  bottom halves of the base.
  • Remove the following screws that secure the top and bottom halves of the base.

    • One 1/4 Phillips screw

    • One TA-20 screw

  • Both screwdrivers must have a minimum of a three inch shank (length).

  • Screwdrivers with extenders will not fit down the access holes.

添加评论

Lift the top half of the base from the bottom half of the base to reveal the internal mechanism.
  • Lift the top half of the base from the bottom half of the base to reveal the internal mechanism.

添加评论

Tug on wires in the marked locations to make sure they are secure.
  • Tug on wires in the marked locations to make sure they are secure.

  • If the wire stays still, the connection is secure.

    • If you still have problems with the blender, it is probably a problem with the motor. Since the motor is irreplaceable, you will have to order a new blender.

添加评论

If the wire comes off, the connection is insecure. You will need to solder the connection to make it solid again.
  • If the wire comes off, the connection is insecure. You will need to solder the connection to make it solid again.

  • If you don't know how to solder, here is a link to show you how. http://www.aaroncake.net/electronics/sol...

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

4等其他人完成本指南。

Elmer Pres Urbano

于2012年10月05日注册

142 信誉积分

撰写一个指南

团队

Cal Poly, Team 6-34, Regan Fall 2012 Cal Poly, Team 6-34, Regan Fall 2012 的会员

CPSU-REGAN-F12S6G34

4 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 9

过去的30天: 29

总计 2,240