简介

This guide will show you how to remove a PCI card on your HP Compaq dx2000MT.

  1. Turn off your computer and remove the power cable by pulling it straight out of its socket.
    • Turn off your computer and remove the power cable by pulling it straight out of its socket.

  2. Remove the 2 Phillips #2 screws that secure the case door to the device.
    • Remove the 2 Phillips #2 screws that secure the case door to the device.

    • Remove the side case door by pushing towards the rear of the device with your hand.

      • This may take considerable force so keep pushing!

    • Once you slide the door back, remove it by pulling it outwards from the device.

    • Remove the side case door by pushing towards the rear of the device with your hand.

      • Once again, this may take considerable force.

    • Once you slide the door back, remove it by pulling it outwards from the device.

    • Remove the Torx T15 screwdriver holding the PCI card in place.

    • Remove the PCI card by pulling it out towards the side of the device.

    • Be careful about touching the top and bottom of the card! The static electricity in your fingers could short it. If you can, only touch the metal bracket and the sides of the card.

结论

To reassemble your device, follow these instructions in reverse order.

6等其他人完成本指南。

Logan Pace

于2011年10月12日注册

2,020 信誉积分

创作了9篇指南

团队

Cal Poly, Team 17-16, Regan Fall 2011 Cal Poly, Team 17-16, Regan Fall 2011 的会员

CPSU-REGAN-F11S17G16

4 名成员

创作了17篇指南

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 43

总计 4,345