简介

This guide will give a step by step procedure of how to remove and replace the front and back covers of the Canon PowerShot A550.

Unscrew  a total of 6 4.45 mm phillips head screws using a #00 phillips head screwdriver.
  • Unscrew a total of 6 4.45 mm phillips head screws using a #00 phillips head screwdriver.

  • There are 2 screws on the left side (when looking at the front of the camera).

  • There are 3 screws on the bottom

  • There is 1 screw on the right side

添加评论

Turn to the bottom of the camera.
  • Turn to the bottom of the camera.

  • Open the memory card cover by sliding the "CARD/BATT." button up, and then pulling the cover to the left.

添加评论

  • This is what the SD card/battery compartment looks like when opened.

  • Remove one 4.45mm phillips head screw from the SD card/battery compartment using a #00 phillips head screwdriver.

添加评论

  • Gently remove the front cover away from the camera body.

  • Tip: Start by loosening the teeth on the left side of the camera next to the battery compartment.

添加评论

  • The camera should look like this once the front cover is removed.

添加评论

  • Start from the battery compartment and remove the back cover.

  • Caution: Do not tug on the back cover after it is removed. This could tear the ribbon attaching the back cover to the camera body.

  • Remove the connecting ribbon from the body of the camera using a pair of tweezers.

添加评论

  • Once the ribbon connecting the back cover is removed, the back of the camera body should look like this.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Shaelyn Thomas

于2011年04月19日注册

287 信誉积分

创作了8篇指南

团队

Cal Poly, Team 8-6, Regan Spring 2011 Cal Poly, Team 8-6, Regan Spring 2011 的会员

CPSU-REGAN-S11S8G6

4 名成员

创作了15篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 3

过去的30天: 12

总计 3,370