跳转到主内容

修复你的物品

维修的权力

商店

简介

This guide will help you replace the top outer casing of the mouse that holds some of the electronics for the LED lighting. Be sure to use caution when unplugging the wires, for this could result in the mouse not working properly. Also use caution when removing the plastic shell, it is fragile and it could be cracked upon removal.

配件

没有特定配件。

  1. Peel back the two teflon tape from the top corners and the one larger one from the bottom with a spudger.
    • Peel back the two teflon tape from the top corners and the one larger one from the bottom with a spudger.

  2. Remove the four 7mm screws using a Phillips #00 screwdriver.
    • Remove the four 7mm screws using a Phillips #00 screwdriver.

  3. Gently remove the top plastic plate of the mouse.
    • Gently remove the top plastic plate of the mouse.

    • Unplug the white cord from the circuit board.

  4. Lightly pull the two plastic sides of the mouse to remove them.
    • Lightly pull the two plastic sides of the mouse to remove them.

结论

To reassemble your device, follow these instructions in reverse order.

5等其他人完成本指南。

Gianni Conti

于2018年01月29日注册

461 信誉积分

创作了2篇指南

do you know where i can get a new top body section? i have a molten that stopped left clicking on every click, i opened it up and the plastic pretty much was worn away

pipsqueak642 - 回复

i’m after the rubber adhesive for the side of this mouse if any one knows where to buy it from cheers.

mayo22 - 回复

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 5

过去的30天: 22

总计 1,034