简介

Follow these steps to disassemble the drill and replace the planetary gear for the RIDGID R84015 X2 power drill.

  1. Remove the backplate.
    • Remove the backplate.

    • Using a Torx T20 screwdriver, remove the four screws attaching the back plate.

    添加评论

  2. Remove the drill handle.
    • Remove the drill handle.

    • Using the Phillips #2 screwdriver, remove the five screws attaching the drill handle to the body.

    添加评论

    • Remove the gear casing from the body.

    • Using the Philips #2 screwdriver, remove the four screws attaching the gear casing to the body.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Prepare to remove the gear chamber.

    • Using the Phillips #2 screwdriver, unscrew the four screws at the rear of the plastic gear chamber.

    添加评论

    • Remove the motor from the drill by gently pulling the motor away from the gear chamber.

    • NOTE: Handle the gear chamber with caution as the gears are now loose.

    添加评论

    • Remove the plastic gear chamber.

    • Using the Phillips #2 screwdriver, remove the four screws that attach the plastic gear chamber.

    添加评论

    • Remove each component from the gear assembly. Replace components as needed.

    • Reassemble the drill following the gear replacement instructions in reverse order.

    添加评论

终点

2等其他人完成本指南。

Evan Long

于2010年04月15日注册

232 信誉积分

创作了4篇指南

团队

Cal Poly, Team 15-48, Garner Spring 2010 Cal Poly, Team 15-48, Garner Spring 2010 的会员

CPSU-GARNER-S10S15G48

6 名成员

创作了5篇指南

Very helpful, thank you! I was not sure how to detach the motor from the gearbox and didn't want to apply any brute force, and this explained it well.

YURIY - 回复

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 1

过去的30天: 16

总计 5,438