简介

Replacing the onboard speaker for the RCA CC310.

Remove the 6-7.9mm ph#0 screws on the back and bottom. Remove the one 3.8mm ph#0 screw on the bottom.
  • Remove the 6-7.9mm ph#0 screws on the back and bottom.

  • Remove the one 3.8mm ph#0 screw on the bottom.

  • Remove the two 7.5mm ph#0 screws on the back and bottom.

添加评论

Remove 5.8mm ph#1 screw from the side button panel. Slide the viewfinder all the way to the right and remove the 7.9mm ph#0 screw.
  • Remove 5.8mm ph#1 screw from the side button panel.

  • Slide the viewfinder all the way to the right and remove the 7.9mm ph#0 screw.

添加评论

Pry along the seam on the top side near the buttons with a spudger. Pry along the seam on the top side near the buttons with a spudger.
  • Pry along the seam on the top side near the buttons with a spudger.

添加评论

Pull the left panel away from the rest of the camcorder. Unplug the red speaker cable located at the rear of the device.
  • Pull the left panel away from the rest of the camcorder.

  • Unplug the red speaker cable located at the rear of the device.

  • Be careful to not pull too hard. The speaker cable is still connected to the panel and it can rip.

添加评论

Unplug the red cable connecting the speaker to the motherboard. Unplug the red cable connecting the speaker to the motherboard.
  • Unplug the red cable connecting the speaker to the motherboard.

添加评论

Locate the speaker on the removed panel. Find the groove on the top left side of the speaker. Pry the plastic up with a spudger until the glue breaks and the speaker is detached.
  • Locate the speaker on the removed panel. Find the groove on the top left side of the speaker.

  • Pry the plastic up with a spudger until the glue breaks and the speaker is detached.

添加评论

Break the plastic pieces holding the cable to the panel.
  • Break the plastic pieces holding the cable to the panel.

  • Glue the new cables, with a hot glue gun, back to the panel after replacing the speaker.

添加评论

Glue the new speaker to the panel. Plug the cable back into the motherboard. Plug the cable back into the motherboard.
  • Glue the new speaker to the panel.

  • Plug the cable back into the motherboard.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Oliver Adams

于2011年01月19日注册

620 信誉积分

创作了6篇指南

团队

Cal Poly, Team 5-20, Amido Winter 2011 Cal Poly, Team 5-20, Amido Winter 2011 的会员

CPSU-AMIDO-W11S5G20

4 名成员

创作了7篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 2

总计 810