跳转到主内容

简介

This guide will instruct you to replace the effect button circuit board on the RCA CC310.

  1. RCA CC310 Effect Button Circuit Board Replacement, Disassembling RCA CC310 Left Cover: 步骤 1 中的图像 1,2 RCA CC310 Effect Button Circuit Board Replacement, Disassembling RCA CC310 Left Cover: 步骤 1 中的图像 2,2
    • Remove the six 7.9mm Phillips #0 screws on the back and bottom.

    • Remove the one 3.8mm Phillips #0 screw on the bottom.

    • Remove the two 7.5mm Phillips #0 screws on the back and bottom.

  2. RCA CC310 Effect Button Circuit Board Replacement: 步骤 2 中的图像 1,2 RCA CC310 Effect Button Circuit Board Replacement: 步骤 2 中的图像 2,2
    • Remove 5.8mm Phillips #1 screw from the side button panel.

    • Slide the viewfinder all the way to the right and remove the 7.9mm Phillips #0 screw.

  3. RCA CC310 Effect Button Circuit Board Replacement: 步骤 3 中的图像 1,2 RCA CC310 Effect Button Circuit Board Replacement: 步骤 3 中的图像 2,2
    • Pry along the seam on the top side near the buttons with a spudger.

  4. RCA CC310 Effect Button Circuit Board Replacement: 步骤 4 中的图像 1,2 RCA CC310 Effect Button Circuit Board Replacement: 步骤 4 中的图像 2,2
    • Pull the left panel away from the rest of the camcorder.

    • Unplug the red speaker cable located at the rear of the device.

    • Be careful to not pull too hard. The speaker cable is still connected to the panel and it can rip.

  5. RCA CC310 Effect Button Circuit Board Replacement, Effect Button Circuit Board: 步骤 5 中的图像 1,2 RCA CC310 Effect Button Circuit Board Replacement, Effect Button Circuit Board: 步骤 5 中的图像 2,2
    • Unplug the two cables on the bottom of the effect button circuit board.

    • Unplug the cable at the top left side of the motherboard.

  6. RCA CC310 Effect Button Circuit Board Replacement: 步骤 6 中的图像 1,3 RCA CC310 Effect Button Circuit Board Replacement: 步骤 6 中的图像 2,3 RCA CC310 Effect Button Circuit Board Replacement: 步骤 6 中的图像 3,3
    • Pull the plastic tabs away from the circuit board.

    • Pull the board away from the camcorder.

    • Use a spudger to help push the mini-circuit board away from the camcorder at the same time.

    • Unplug the cable in the middle of the effects board.

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Oliver Adams

于2011年01月19日注册

629 声望分

创作了6篇指南

团队

Cal Poly, Team 5-20, Amido Winter 2011 Cal Poly, Team 5-20, Amido Winter 2011 的会员

CPSU-AMIDO-W11S5G20

4 名成员

创作了7篇指南

0条评论

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 5

总计 1,579