修复你的物品 社区 商店

PowerBook G4 Titanium DVI DC-In Board Replacement

简介

Tripped over your power cord? At least you don't have to replace the entire logic board.

你所需要的

  1. PowerBook G4 Titanium DVI DC-In Board Replacement, Battery: 步骤 1 中的图像 1，2 PowerBook G4 Titanium DVI DC-In Board Replacement, Battery: 步骤 1 中的图像 2，2

    • Locate the battery release tab on the underside of the G4.

    • Slide the battery release tab to the left and lift the battery out of the computer.

    编辑

  2. PowerBook G4 Titanium DVI DC-In Board Replacement, Lower Case: 步骤 2 中的图像 1，2 PowerBook G4 Titanium DVI DC-In Board Replacement, Lower Case: 步骤 2 中的图像 2，2

    • Remove the seven T8 Torx screws from the lower case.

    • Using your thumbs, slide the lower case toward the front of the computer.

    • The lower case may stick in the front on a tab just above the center of the optical drive. Be careful as you work the case off, or you may break the thin strip of plastic just above the drive.

    • Lift the lower case off.

    编辑

  4. PowerBook G4 Titanium DVI DC-In Board Replacement, DC-In Board: 步骤 3 中的图像 1，1

    • Disconnect the large DC-In connector from the right side of the logic board.

    编辑

  5. PowerBook G4 Titanium DVI DC-In Board Replacement: 步骤 4 中的图像 1，1

    • Remove the two T6 Torx screws from the DC-In board.

    编辑

  6. PowerBook G4 Titanium DVI DC-In Board Replacement: 步骤 5 中的图像 1，1

    • Lift the DC-In board out of the computer by pulling up and away from you.

    • If you don't have a 667 MHz computer, there is a fan in this location which makes it a bit difficult to remove the DC-In board.

    • If there is a fan present, rotate the DC-In board slightly clockwise before easing it out at a slight angle in order to clear the fan clamp on top of it.

    编辑
结论

To reassemble your device, follow these instructions in reverse order.

4等其他人完成本指南。

附加文件

作者

与5其他贡献者

iRobot

于09/24/09注册

1 声望

创作了636篇指南

徽章: 36

+ 33更多徽章

0条评论

添加评论

浏览统计数据:

过去 24 小时： 1

过去 7 天： 6

过去 30 天： 11

总计 15,381