跳转到主内容

简介

Use this guide to replace the CD-ROM drive in your Power Mac G5.

工具

没有特定工具。

配件

没有特定配件。

  1. To avoid electrocution, shut down the computer. Do not open the computer or attempt to install any items inside it while the computer is on.
    • To avoid electrocution, shut down the computer. Do not open the computer or attempt to install any items inside it while the computer is on.

    • To avoid being burned, wait at least 10 minutes to allow the computer's internal components to cool.

  2. Remove all the cables, including the power cables before opening the unit.
    • Remove all the cables, including the power cables before opening the unit.

  3. Lift the tab to unlock the side panel. The panel should fall out. If the panel does not fall out by itself pull a little from the edges.
    • Lift the tab to unlock the side panel.

    • The panel should fall out. If the panel does not fall out by itself pull a little from the edges.

  4. Remove the air deflector (the clear plastic cover) by pulling on the handle. Remove the air deflector (the clear plastic cover) by pulling on the handle. Remove the air deflector (the clear plastic cover) by pulling on the handle.
    • Remove the air deflector (the clear plastic cover) by pulling on the handle.

  5. Locate the CD-ROM Drive on the top left corner of desktop.
    • Locate the CD-ROM Drive on the top left corner of desktop.

  6. Pull and rotate latches to the left. Pull and rotate latches to the left. Pull and rotate latches to the left.
    • Pull and rotate latches to the left.

  7. Wiggle and pull out the CD Drive.
    • Wiggle and pull out the CD Drive.

  8. Detach the first cable from the CD-ROM drive. Detach the second cable from the CD-ROM drive.
    • Detach the first cable from the CD-ROM drive.

    • Detach the second cable from the CD-ROM drive.

    • On some models, the IDE cable is stuck to the top of the CD-ROM with foam tape. It is easier to unplug the IDE connector from the motherboard, and de-route the IDE cable as you remove the drive.

  9. After the CD-ROM drive is removed, the area should look like this.
    • After the CD-ROM drive is removed, the area should look like this.

结论

To reassemble your device, follow these instructions in reverse order.

37等其他人完成本指南。

Jessica Chaidez

于2010年01月13日注册

7,581 信誉积分

创作了3篇指南

团队

Cal Poly, Team 5-8, Forte Winter 2010 Cal Poly, Team 5-8, Forte Winter 2010 的会员

CPSU-FORTE-W10S5G8

7 名成员

创作了11篇指南

Is it possible to use an IDE to SATA connector? I want to install my Pioneer BDR burner to potentially use the PMG5 for data disc burning only. Any thoughts?

nirv - 回复

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 14

过去的30天: 52

总计 31,799