简介

Replacement of the speakers requires the removal of the battery. Be careful when handling the battery and avoid using sharp metal objects when ever possible.

  1. Flip the laptop over with the screen facing down to reveal the bottom panel.
    • Flip the laptop over with the screen facing down to reveal the bottom panel.

    • Unscrew each of the highlighted screws with a Phillips #0 screwdriver.

    添加评论

  2. Use a metal spudger to remove fitting and reveal the screw.
    • Use a metal spudger to remove fitting and reveal the screw.

    • Use a screwdriver with a Torx T7 bit to remove the screw.

    添加评论

    • The SD Card slot is on the top right corner of the device near the headphone jacks.

    • Depress the fake SD Card and release.

    • Pull the fake SD Card out and remove it completely from the slot, as this will help in the removal of the backplate.

    添加评论

    • Lift the back plate starting at the opposing edge to the SD card. Lift from left to right and continue lifting this plate at this angle until it's free from the laptop.

    • Once the backplate is completely off, this will reveal the inside components of the device.

    • Upon reassembly of the back cover, make sure to line up the two headphone jacks on the upper right corner with the holes in the back cover or else it will not seat fully.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • The battery is the black rectangular piece in the bottom half of the device.

    • Remove six 5mm screws holding down the battery using a Phillips PH0 screwdriver.

    • Lift the battery and separate from its place holder.

    • Do not fully remove the battery as it is still connected by the connector in the top right corner.

    添加评论

    • Using the nylon spudger, disconnect the white plugin.

    • Once the wire has been disconnected you may remove the battery.

    添加评论

    • There are two black speakers on either side of the bottom corner of the device.

    • Remove tape securing speaker wires to frame.

    添加评论

    • Using a blue plastic opening tool, disconnect the white cable running from the trackpad to the motherboard, at themotherboard port.

    • Disconnect the cable gently and do not yank on cable, this step is to get the cable out out of the way of speaker wires.

    添加评论

    • The speakers are connected by a plug with wires (Red/Black) (Black/White) to the motherboard.

    • Simply remove the plug with your fingers, disconnecting the speakers from the motherboard.

    添加评论

    • With the plug disconnected, now you can remove the speakers.

    • Lift the speakers up vertically removing them from pegs that hold them in place.

    • This does not require a tool as they are not fastened down, just lift and remove.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Tanner Krygier

于2018年09月17日注册

857 信誉积分

创作了5篇指南

团队

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 8

过去的30天: 23

总计 31