Unscrew and remove the four screws from the left side of the camera (from the screen's view) Unscrew and remove the four screws from the left side of the camera (from the screen's view)
  • Unscrew and remove the four screws from the left side of the camera (from the screen's view)

添加评论

Unscrew and remove the three screws from the bottom of the camera
  • Unscrew and remove the three screws from the bottom of the camera

添加评论

Unscrew and remove the two screws from the right side of the camera. Unscrew and remove the two screws from the right side of the camera.
  • Unscrew and remove the two screws from the right side of the camera.

添加评论

Open the battery flap and remove the batteries. Keep the battery flap open.
  • Open the battery flap and remove the batteries.

  • Keep the battery flap open.

添加评论

Use a spudger to gently separate the two halves of the camera's outer casing.
  • Use a spudger to gently separate the two halves of the camera's outer casing.

添加评论

Mac RAM 套件
加速你的Mac。充分利用它的内存。
Mac RAM 套件
从Mac中清理出更多内存。
Gently pull the half of the case with the screen (the back half) from the rest of the camera.
  • Gently pull the half of the case with the screen (the back half) from the rest of the camera.

  • Be sure not too pull to hard. The screen is still attached to the motherboard. If you pull too hard you will rip it.

添加评论

The back half (the half with the screen on it) should now be separate from the rest of the camera, but still attached by the ribbon. The back half (the half with the screen on it) should now be separate from the rest of the camera, but still attached by the ribbon.
  • The back half (the half with the screen on it) should now be separate from the rest of the camera, but still attached by the ribbon.

添加评论

Use a spudger to lift the black flap that clamps the ribbon towards you. When the black flap is open it will be straight up. (like in the second picture)
  • Use a spudger to lift the black flap that clamps the ribbon towards you.

  • When the black flap is open it will be straight up. (like in the second picture)

添加评论

Now that the black flap is open, gently pull the ribbon out.
  • Now that the black flap is open, gently pull the ribbon out.

  • You should now have the back half of the camera completely separate from the rest of the camera.

添加评论

This is what the back half of the camera should look like. This is what the rest of the camera will look like.
  • This is what the back half of the camera should look like.

  • This is what the rest of the camera will look like.

添加评论

Unscrew and remove two screws from the logic board.
  • Unscrew and remove two screws from the logic board.

添加评论

Pull the front half off of the logic board.
  • Pull the front half off of the logic board.

添加评论

This will be the front half of the outer case.
  • This will be the front half of the outer case.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Terichael Office

于2010年06月24日注册

9 信誉积分

创作了2篇指南

团队

Cal Poly, Team 3-4, Johann Summer 2010 Cal Poly, Team 3-4, Johann Summer 2010 的会员

CPSU-JOHANN-R10S3G4

4 名成员

创作了4篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 1

总计 1,229