Polaroid SNAP Front and Back Face Plate Removal - iFixit 维修指南

简介

This guide will show users how to remove the front and back face plates of the Polaroid SNAP.

你所需要的

步骤 1 Polaroid SNAP Front and Back Face Plate Removal

Polaroid SNAP Front and Back Face Plate Removal, Polaroid SNAP Front and Back Face Plate Removal: 步骤 1 中的图像 1，1

Open the paper door of the camera, then locate and remove the screws that are on the top and bottom edge of the inside of the camera.
Screw head: Phillips, Screw length: 3mm

步骤 2

Polaroid SNAP Front and Back Face Plate Removal: 步骤 2 中的图像 1，2

Polaroid SNAP Front and Back Face Plate Removal: 步骤 2 中的图像 2，2

Push the rear face plate from the short side nearest the screws you just removed towards the other short side of the camera. It should slide forward and unlock the clips holding it in place.
Then it should be easy to simply lift the rear face plate up and remove it.

步骤 3

Polaroid SNAP Front and Back Face Plate Removal: 步骤 3 中的图像 1，2

Polaroid SNAP Front and Back Face Plate Removal: 步骤 3 中的图像 2，2

Locate and remove the four screws on the corners of the camera, they're quite small and may be difficult to remove.
Screw head: Philips, Screw length: 5mm

步骤 4

Polaroid SNAP Front and Back Face Plate Removal: 步骤 4 中的图像 1，3

Polaroid SNAP Front and Back Face Plate Removal: 步骤 4 中的图像 2，3

Polaroid SNAP Front and Back Face Plate Removal: 步骤 4 中的图像 3，3

Once the screws are removed, flip the camera over
Use a plastic opening tool to disengage the six clips until the front face plate can be removed safely

步骤 5

Polaroid SNAP Front and Back Face Plate Removal: 步骤 5 中的图像 1，1

The cameras innards should now be accessible to you

结论

To reassemble your device, follow these instructions in reverse order.

作者

与4其他贡献者

Aaron Hall

于02/09/16注册

500 声望

撰写一个指南

+ 9更多徽章

团队

USF Tampa, Team 7-3, Cheng Spring 2016 USF Tampa, Team 7-3, Cheng Spring 2016 的会员

USFT-CHENG-S16S7G3

4 名成员

创作了18篇指南

0条评论

浏览统计数据:

过去 24 小时： 0

过去 7 天： 0

过去 30 天： 0

总计 74