Skip to main content

介绍

This will guide you through the process of replacing your logic board.

配件

没有特定配件。

  1. Remove the parallel port cover on the back of the PlayStation.
    • Remove the parallel port cover on the back of the PlayStation.

  2. Flip over the PlayStation and remove the six screws from the bottom.
    • Flip over the PlayStation and remove the six screws from the bottom.

  3. Turn the PlayStation upright. Remove the cover by lifting it up.
    • Turn the PlayStation upright. Remove the cover by lifting it up.

  4. Carefully disconnect the gold-colored ribbon cable from it's connector.
    • Carefully disconnect the gold-colored ribbon cable from it's connector.

    • To avoid damaging the cable, pull it by the white, reinforced tab.

  5. Disconnect the second cable by pulling up on the plastic connector at the end.
    • Disconnect the second cable by pulling up on the plastic connector at the end.

  6. Android 维修工具包

    一个新的屏幕或电池就在一个套件之内。

    现在开始购物

    Android 维修工具包

    一个新的屏幕或电池就在一个套件之内。

    现在开始购物
  7. Lift the optical drive off of the PlayStation.
    • Lift the optical drive off of the PlayStation.

  8. Remove the four screws from the logic board's metal cover.
    • Remove the four screws from the logic board's metal cover.

  9. Detach power supply connector from logic board by pulling on the plastic tab.
    • Detach power supply connector from logic board by pulling on the plastic tab.

  10. Detach white ribbon cable from logic board by gently lifting on it.
    • Detach white ribbon cable from logic board by gently lifting on it.

  11. With one hand, hold the main board’s protective metal cover. With your other hand, wedge the spudger in between the right side of the protective cover and the thin metal clamps that surround it.
    • With one hand, hold the main board’s protective metal cover. With your other hand, wedge the spudger in between the right side of the protective cover and the thin metal clamps that surround it.

    • With the spudger in place, gently lift the upper portion of the metal cover. The cover should detach from the right side.

  12. Using the same process from the previous step, wedge the spudger between the clamps and metal cover on the bottom side (as shown in the picture).
    • Using the same process from the previous step, wedge the spudger between the clamps and metal cover on the bottom side (as shown in the picture).

    • With your other hand, pull up on the top right corner of the metal cover to lift it off.

  13. Remove the last four screws from the logic board.
    • Remove the last four screws from the logic board.

  14. Lift the logic board out of the PlayStation and replace with a new logic board.
    • Lift the logic board out of the PlayStation and replace with a new logic board.

结论

To reassemble your device, follow these instructions in reverse order.

13等其他人完成本指南。

JakeDeschamps

于2009年10月28日注册

1,065 Reputation

创作了5篇指南

Team

Cal Poly, Team 5-2, Regan Fall 2009 Cal Poly, Team 5-2, Regan Fall 2009 的会员

CPSU-REGAN-F09S5G2

5 名成员

创作了14篇指南

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 5

Past 30 Days: 57

All Time: 18,850