简介

This will guide you through the replacement of your controller port.

配件

无需配件。

Remove the parallel port cover on the back of the PlayStation.
  • Remove the parallel port cover on the back of the PlayStation.

The SCPH-9001 model does not have the Parallel Port panel to remove.

Aislinn - 回复

Flip over the PlayStation and remove the six screws from the bottom.
  • Flip over the PlayStation and remove the six screws from the bottom.

添加评论

Turn the PlayStation upright. Remove the cover by lifting it up.
  • Turn the PlayStation upright. Remove the cover by lifting it up.

添加评论

Remove the two screws securing the controller port to the case. Remove the two screws securing the controller port to the case.
  • Remove the two screws securing the controller port to the case.

添加评论

Gently disconnect the ribbon cable from the logic board. This is done by pulling on the blue area of the cable near the connector.
  • Gently disconnect the ribbon cable from the logic board. This is done by pulling on the blue area of the cable near the connector.

添加评论

Remove and replace the controller port.
  • Remove and replace the controller port.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

6等其他人完成本指南。

JakeDeschamps

于2009年10月28日注册

1,013 信誉积分

创作了9篇指南

团队

Cal Poly, Team 5-2, Regan Fall 2009 Cal Poly, Team 5-2, Regan Fall 2009 的会员

CPSU-REGAN-F09S5G2

5 名成员

创作了9篇指南

I try replacing the controller and still wouldn't play memory cards.

redevil19 - 回复

I changed the controller port but the psx still doesn't recognize any controller. Both controller port and ribbon cable work perfect in other console. I wonder which components on the mother board are related with the controller ports so I can check them with a tester.

Daniel Prieto - 回复

I replaced the PS605 fuse and now the controllers work again! Thanks to this video https://www.youtube.com/watch?v=HdULot5F...

Daniel Prieto -

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 27

过去的30天: 109

总计 18,035