跳转到主内容

简介

This guide will show you how to locate and replace the Infrared Sensor in the Playstation 2 Slimline. The IR sensor reads wireless signals so PS2 controllers and remotes function as if they were plugged into the unit.

配件

没有特定配件。

  1. Disconnect all cables from the console and flip the unit over to reveal its base.
    • Disconnect all cables from the console and flip the unit over to reveal its base.

  2. Locate the 6 feet on the base of the unit. Pry them off using a spudger to reveal the screws. Note: One of the feet is located under the sticker shown in the photo. Removing this sticker will void any warranty with Sony. Note: One of the feet is located under the sticker shown in the photo. Removing this sticker will void any warranty with Sony.
    • Locate the 6 feet on the base of the unit. Pry them off using a spudger to reveal the screws.

    • Note: One of the feet is located under the sticker shown in the photo. Removing this sticker will void any warranty with Sony.

  3. Remove all six 4.0 mm screws from the base of the unit using a #1 Phillips screwdriver. Remove all six 4.0 mm screws from the base of the unit using a #1 Phillips screwdriver. Remove all six 4.0 mm screws from the base of the unit using a #1 Phillips screwdriver.
    • Remove all six 4.0 mm screws from the base of the unit using a #1 Phillips screwdriver.

  4. Android 维修工具包

    A new screen or battery is one kit away.

    现在开始购物

    Android 维修工具包

    A new screen or battery is one kit away.

    现在开始购物
  5. Starting at the corner at which the power and Ethernet ports are located, pry open the outer shell using a spudger and continue around the entire unit. Note: You may use your hands for additional force to separate the two pieces of the outer shell. Note: You may use your hands for additional force to separate the two pieces of the outer shell.
    • Starting at the corner at which the power and Ethernet ports are located, pry open the outer shell using a spudger and continue around the entire unit.

    • Note: You may use your hands for additional force to separate the two pieces of the outer shell.

  6. Locate the IR sensor at the front, right corner of the unit.
    • Locate the IR sensor at the front, right corner of the unit.

  7. Gently detach the ribbon cable connecting the IR sensor to the motherboard.
    • Gently detach the ribbon cable connecting the IR sensor to the motherboard.

    • Caution: Always remove ribbon cables by the plastic handles located on either end. Gripping a ribbon cable anywhere but the provided handles can damage the cable and render the component useless.

  8. Gently lift and remove the IR Sensor from its designated slot.
    • Gently lift and remove the IR Sensor from its designated slot.

结论

To reassemble your device, follow these instructions in reverse order.

4等其他人完成本指南。

Thomas Sullivan

于2013年10月23日注册

2,510 信誉积分

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 7

过去的30天: 23

总计 3,602