Introduction

This guide will show you how to locate and replace the fan in the PlayStation 2 Slimline.

Disconnect all cables from the console and flip the unit over to reveal its base.
  • Disconnect all cables from the console and flip the unit over to reveal its base.

Add Comment

Locate the 6 feet on the base of the unit. Pry them off using a spudger to reveal the screws.
  • Locate the 6 feet on the base of the unit. Pry them off using a spudger to reveal the screws.

  • Note: One of the feet is located under the sticker shown in the photo. Removing this sticker will void any warranty with Sony.

Add Comment

  • Remove all six 4.0 mm screws from the base of the unit using a #1 Phillips screwdriver.

Add Comment

  • Starting at the corner at which the power and Ethernet ports are located, pry open the outer shell using a spudger and continue around the entire unit.

  • Note: You may use your hands for additional force to separate the two pieces of the outer shell.

Add Comment

  • Locate the fan at the front, left section of the unit.

Add Comment

  • Peel off the sticker holding the power cords to the unit.

Add Comment

  • Lift the connector from the motherboard with a pair of tweezers using a firm, upward force.

Add Comment

  • Remove all three 1.6 mm screws fastening the fan to the unit using a #1 Phillips screwdriver.

  • Gently lift and remove the fan from its compartment.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

6 other people completed this guide.

Thomas Sullivan

Member since: 10/23/2013

2,211 Reputation

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 8

Past 30 Days: 26

All Time: 2,462