简介

Follow the procedure outlined in this guide to remove and install a speaker.

  1. Pry off the four white feet with the pointed end of the spudger
    • Pry off the four white feet with the pointed end of the spudger

    添加评论

  2. Unscrew the four 15.5 mm Phillips #2 screws that hold the bottom panel to the dock.
    • Unscrew the four 15.5 mm Phillips #2 screws that hold the bottom panel to the dock.

    添加评论

    • Use the flat end of the spudger to pry the lid off from the two connectors holding it to the body of the dock.

    • The connectors on the panel are fragile and may break.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Carefully pull up and out the four electrical connectors and the two ribbon connectors connecting the bottom panel and the dock.

      • Electrical Connectors

      • Ribbon Connectors

    • The cables do not have a lot of slack in them. Be careful not to break the connectors.

    • One wire is soldered onto the bottom panel. Be careful not to break this bond.

    添加评论

    • Unscrew the two 6 mm Phillips #00 screws attaching the back panel to device.

    添加评论

    • Slide the back panel towards top of the device and lift away from the device to detach back panel.

    添加评论

    • Unscrew the four 16 mm Phillips #2 screws attaching the speaker unit to device.

    添加评论

    • Slide the speaker towards the bottom of the device to remove.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Graham Rolph

于2013年04月18日注册

1 信誉积分

创作了2篇指南

团队

Cal Poly, Team 3-48, Amido Spring 2013 Cal Poly, Team 3-48, Amido Spring 2013 的会员

CPSU-AMIDO-S13S3G48

4 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 2

过去的30天: 9

总计 594