修复你的物品 社区 商店

Pebble Time Steel - reparing of a non working button

简介

The watch is opened and i think it won't be waterrestant any more after this.

你所需要的

  1. Pebble Time Steel - reparing of a non working button, Repairing of a non working button: 步骤 1 中的图像 1，2 Pebble Time Steel - reparing of a non working button, Repairing of a non working button: 步骤 1 中的图像 2，2

    • With opening picks we start to open the watch by lifting up the display bottom from left (about seven o'clock) in counterclockwise direction. In the left side there is a flexband that has to be disconnected.

    翻译

  2. Pebble Time Steel - reparing of a non working button: 步骤 2 中的图像 1，1

    • Three screws are removed.

    翻译

  4. Pebble Time Steel - reparing of a non working button: 步骤 3 中的图像 1，1

    • down on the left, a Flexband is carefully folded up and loosened. Below it, another screw is visible.

    • Remove this screw.

    翻译

  5. Pebble Time Steel - reparing of a non working button: 步骤 4 中的图像 1，2 Pebble Time Steel - reparing of a non working button: 步骤 4 中的图像 2，2

    • Then the board can be removed carefully.

    • If you look closely at the keys, you can see that the defective key no longer carries rubber dabs.

    • With a needle, the smallest drops of superglue are dripped into place of the missing rubber.

    翻译

    • Now put everything together in reverse order. Remove the sealant before applying the display and stick it around with a new Tesa 61395 Tape 1mm.

    • Then insert the display and press down.

    翻译
结论

Repeat the steps in reverse order to reassemble your device.

2等其他人完成本指南。

由衷感谢以下译者：

de en

100%

Vasco Dunker

Ian

这些译者帮助我们修补全世界！ 您也想加入吗？
开始翻译 ›

作者

与1其他贡献者

Vasco Dunker

于12/02/18注册

256 声望

撰写一个指南

徽章: 6

+ 3更多徽章

2条评论

thanks , I managed to fix my pebble time steel with this guide. it may not be waterproof but at least my buttons no longer stick…

I think the reason it failed was because some water already got inside… could get my pebble starting anymore

Kah Kin Yau - 回复

Works great! Thanks for the guide :D

I would've liked to add an additional step, but it doesn't appear that I can - one other thing that I've found can cause buttons to stick is in the inside of the casing, on each button there's a little circlip that sits in a detent on the pokey bit - if this comes out of its detent, then the button can become quite hard to press and hard to work with. Unfortunately I can't post pictures here, but there's a picture in this Imgur thread of what I'm talking about: https://imgur.com/gallery/V4SUvbz

Aadi Bhamidipati - 回复

添加评论

浏览统计数据:

过去 24 小时： 2

过去 7 天： 8

过去 30 天： 25

总计 1,661