简介

This guide will show you how to gain access to and replace the track pad board in your Panasonic CF-29.

Locate the bay door for the battery on the left side of the laptop.
  • Locate the bay door for the battery on the left side of the laptop.

添加评论

Slide the latch to the right and then down to unlock it.
  • Slide the latch to the right and then down to unlock it.

  • Pull out the battery.

添加评论

  • Locate the door for the hard drive on the right side of the laptop

添加评论

  • Push and slide the latch up to open the hard drive door.

  • Pull out the hard drive.

添加评论

  • Flip the device upside down with the handle facing away from you.

  • Open the optical drive bay by sliding its latch to the right.

  • Locate optical drive release mechanism on the bottom of the laptop.

添加评论

  • Slide the latch cover to the right.

添加评论

  • Push the exposed switch to the left to eject the optical drive.

添加评论

  • Begin by turning the laptop upside down with the handle towards you.

  • Use a Phillips size 0 screwdriver to remove the 4 screws holding down the ram cover.

添加评论

  • Remove the panel and set it aside.

  • Use a Phillips size 0 screwdriver to remove these 8 small screws.

添加评论

  • Use a Phillips size 1 screwdriver to remove the remaining 8 screws.

添加评论

  • Use a plastic opening tool to release, but NOT remove, the back cover because it is sealed with adhesive.

添加评论

  • Be careful when lifting the cover as you may damage some connections.

  • Slowly lift the cover so that you can disconnect the red and white wires connecting the speaker to the sound card.

添加评论

  • Now the back cover should be off and you can access the inside of the casing.

添加评论

  • Locate the track pad chip near the handle.

  • Remove the upper right screw.

添加评论

  • Use a pry bar to detach the white ribbon cable shown.

  • Push the brown tab to release the cable

添加评论

  • Remove the screw that was previously concealed under the now removed ribbon cable.

添加评论

  • Remove the rightmost ribbon cable

    • Pry up the brown clip

    • Tug the cable out

添加评论

  • Pull the track pad slightly up and to the right.

  • Do not completely remove the circuit board because it is still attached.

添加评论

  • Remove the last ribbon cable.

    • Pry up on the brown part to release the ribbon cable.

添加评论

  • You have successfully removed the track pad board.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Dylan Bloom

于2010年04月12日注册

262 信誉积分

创作了4篇指南

团队

Cal Poly, Team 27-93, Amido Spring 2010 Cal Poly, Team 27-93, Amido Spring 2010 的会员

CPSU-AMIDO-S10S27G93

4 名成员

创作了12篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 2

过去的30天: 7

总计 5,302