简介

This guide provides the steps to remove the back cover. This process is necessary to access many of the components inside.

Locate the bay door for the battery on the left side of the laptop.
  • Locate the bay door for the battery on the left side of the laptop.

添加评论

Slide the latch to the right and then down to unlock it. Pull out the battery.
  • Slide the latch to the right and then down to unlock it.

  • Pull out the battery.

添加评论

Flip the device upside down with the handle facing away from you.
  • Flip the device upside down with the handle facing away from you.

  • Open the optical drive bay by sliding its latch to the right.

  • Locate optical drive release mechanism on the bottom of the laptop.

添加评论

Slide the latch cover to the right.
  • Slide the latch cover to the right.

添加评论

Mac RAM 套件
加速你的Mac。充分利用它的内存。
Mac RAM 套件
从Mac中清理出更多内存。
Push the exposed switch to the left to eject the optical drive. Push the exposed switch to the left to eject the optical drive.
  • Push the exposed switch to the left to eject the optical drive.

添加评论

Begin by turning the laptop upside down with the handle towards you.
  • Begin by turning the laptop upside down with the handle towards you.

  • Use a Phillips size 0 screwdriver to remove the 4 screws holding down the ram cover.

添加评论

Remove the panel and set it aside.
  • Remove the panel and set it aside.

  • Use a Phillips size 0 screwdriver to remove these 8 small screws.

添加评论

Use a Phillips size 1 screwdriver to remove the remaining 8 screws.
  • Use a Phillips size 1 screwdriver to remove the remaining 8 screws.

添加评论

Use a plastic opening tool to release, but NOT remove, the back cover because it is sealed with adhesive. Use a plastic opening tool to release, but NOT remove, the back cover because it is sealed with adhesive.
  • Use a plastic opening tool to release, but NOT remove, the back cover because it is sealed with adhesive.

添加评论

Be careful when lifting the cover as you may damage some connections.
  • Be careful when lifting the cover as you may damage some connections.

  • Slowly lift the cover so that you can disconnect the red and white wires connecting the speaker to the sound card.

添加评论

Now the back cover should be off and you can access the inside of the casing.
  • Now the back cover should be off and you can access the inside of the casing.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Rohun Heesen

于2010年04月13日注册

330 信誉积分

创作了2篇指南

团队

Cal Poly, Team 27-93, Amido Spring 2010 Cal Poly, Team 27-93, Amido Spring 2010 的会员

CPSU-AMIDO-S10S27G93

4 名成员

创作了12篇指南

添加评论

浏览统计数据:

过去的24小时: 2

过去的7天: 6

过去的30天: 26

总计 8,877