简介

Use this guide to replace the back cover which houses the back panel buttons and LCD screen.

配件

无需配件。

Remove the following eleven screws securing the covers to the ZS3 Eleven 3 mm Phillips screws Using too much pressure when removing the screws may strip the screws and complicate screw removal at a later time.
  • Remove the following eleven screws securing the covers to the ZS3

    • Eleven 3 mm Phillips screws

  • Using too much pressure when removing the screws may strip the screws and complicate screw removal at a later time.

On some versions of this model, removing the back cover will suffice for this repair. The back cover is secured by only six screws.

Alex Levine - 回复

Use the flat end of a spudger to pry apart the back cover from the rest of the unit as shown. Be sure to carefully and slowly lift the back cover. Forcefully lifting the back cover and fully separating it at this point may ruin internal connections.
  • Use the flat end of a spudger to pry apart the back cover from the rest of the unit as shown.

  • Be sure to carefully and slowly lift the back cover. Forcefully lifting the back cover and fully separating it at this point may ruin internal connections.

添加评论

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Using your fingernail or a spudger, flip up the ZIF locking flap on the two LCD ribbon cable sockets that connect the back cover to the rest of the unit. Be sure you are opening the locking tab, not pulling against the socket mounted to the board.
  • Using your fingernail or a spudger, flip up the ZIF locking flap on the two LCD ribbon cable sockets that connect the back cover to the rest of the unit.

  • Be sure you are opening the locking tab, not pulling against the socket mounted to the board.

添加评论

Remove the two LCD board ribbon cables out of their sockets.
  • Remove the two LCD board ribbon cables out of their sockets.

There are two ribbon cables: a wide one for the lcd display itself, and a thin one for the backlight. When reassembling, it is easy to reverse the polarity on the backlight cable, in which case the backlight will not work. Make a note of the polarity as you disassemble.

Alex Levine - 回复

when I pried the small band's socket, the socket came off the board. What do I do now ? can I resolder it and where to ????

Karen Kornbau - 回复

结论

To reassemble your device, follow these instructions in reverse order.

Juan Pablo Quinonez Weston

于2013年04月16日注册

4 信誉积分

创作了4篇指南

团队

Cal Poly, Team 13-60, Johann Spring 2013 Cal Poly, Team 13-60, Johann Spring 2013 的会员

CPSU-JOHANN-S13S13G60

3 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 1

总计 626