跳转到主内容

简介

Directions are given as if you were holding the camera to take a picture.

配件

没有特定配件。

  1. Locate the memory card and battery card latch on the bottom of the camera.
    • Locate the memory card and battery card latch on the bottom of the camera.

    • Slide the latch to the open position.

  2. Open the battery latch, and slide the battery release lever to the right.
    • Open the battery latch, and slide the battery release lever to the right.

  3. Remove the battery from the camera.
    • Remove the battery from the camera.

  4. Using a size #00 Phillips screwdriver, remove the three 4.58 mm screws on the bottom of the camera.
    • Using a size #00 Phillips screwdriver, remove the three 4.58 mm screws on the bottom of the camera.

    • Use this screwdriver for all screws in the device.

  5. Remove the 3.15 mm screw on the left side of the camera.
    • Remove the 3.15 mm screw on the left side of the camera.

  6. Remove the left side casing. Remove the left side casing.
    • Remove the left side casing.

  7. Remove the two 3.15 mm screws on the right side of the camera.
    • Remove the two 3.15 mm screws on the right side of the camera.

  8. Remove the bottom right panel.
    • Remove the bottom right panel.

  9. Gently remove the back casing. Start at the bottom and carefully pry towards the top to get this piece free.
    • Gently remove the back casing.

    • Start at the bottom and carefully pry towards the top to get this piece free.

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Andrew

于2010年10月11日注册

384 信誉积分

创作了4篇指南

团队

Cal Poly, Team 9-22, Regan Fall 2010 Cal Poly, Team 9-22, Regan Fall 2010 的会员

CPSU-REGAN-F10S9G22

4 名成员

创作了8篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 4

总计 3,094